On the relationship between the preparation method and the physicochemical and catalytic properties of the CoMo/γ-Al2O3 hydrodesulfurization catalysts

A series of CoMo/gamma-Al2O3 catalysts have been prepared using various methodologies. One of them (EDF) was prepared by depositing the Mo species on the support via the equilibrium deposition filtration (EDF) technique and then the Co species by dry impregnation. Another catalyst (co-EDF) was prepared by depositing the Co and Mo species simultaneously via EDF. A third catalyst (co-WET) was prepared by depositing Mo and Co species simultaneously using the wet impregnation method. The fourth catalyst (WET) was prepared by depositing the Mo species through wet impregnation and then the Co species by dry impregnation. Finally, the fifth catalyst (s-DRY) was prepared by mounting the Mo species through successive dry impregnations and then the Co species by dry impregnation. In all cases the Mo and Co content was identical, giving a Co/(Co + Mo) ratio equal to 0.13. These catalysts were characterized using various physicochemical techniques (BET, NO chemisorption, DRS, LRS, TPR, and XPS), and their catalytic activity for the hydrodesulfurization of thiophene was determined. The trend observed for the HDS activity (namely, EDF > co-EDF > co-WET > s-DRY > WET) is attributed to similar trends observed for both the fraction of well-dispersed octahedral cobalt in the oxidic precursors and the concentration of the edge sulfur vacancies formed on the active phase of the sulfided samples. The EDF and co-EDF catalysts exhibited relatively low hydrogenating activity. The maximum HDS activity, achieved over the EDF catalyst, suggested the most suitable preparative strategy for the preparation of very active and less hydrogen-demanding CoMo/gamma-Al2O3 HDS catalysts. (C) 2003 Elsevier Science (USA). All rights reserved.