VOLATILES RELEASE RATES AND TEMPERATURES DURING LARGE PARTICLE REFUSE DERIVED FUEL - MUNICIPAL SOLID-WASTE DEVOLATILIZATION

被引:17
作者
LAI, WC
KRIEGERBROCKETT, B
机构
[1] Department of Chemical Engineering, University of Washington, Seattle, WA, 98195
基金
美国国家科学基金会;
关键词
REFUSE-DERIVED FUEL; DEVOLATILIZATION; MOIST FUEL; HEATING EFFECT; GASIFICATION; VOLATILES RELEASE; THERMALLY-THICK PARTICLE DEVOLATILIZATION;
D O I
10.1080/00102209208947164
中图分类号
O414.1 [热力学];
学科分类号
摘要
Practices to minimize pollutants from municipal solid waste combustion devices include preparation steps to provide relatively uniform feed particles. This is the rationale behind commercially available densified refuse-derived fuel (d-RDF). However the solid phase devolatilization rate, the composition and rate of production of reaction products and pollutants, and the influence of waste feed properties on these processes have not been quantified. Devolatilization experiments were performed on single, well-characterized d-RDF particles under carefully controlled conditions of practical importance. Intraparticle temperature histories, gas evolution rates and compositions were measured. The results presented here quantify the simultaneous effects of both initial moisture and particle heating rate on the intraparticle temperature field which controls the extent of local reaction. It appears moisture does not strongly alter the overall production of both gases and condensibles (tars) from the devolatilization, as long as the particle is heated with sufficient intensity (at least 5 cal/cm2 at the surface) for a sufficient length of time, and as long as the plastics content is not high. When the initial moisture levels of MSW exceed 15% (dry basis) the rate of volatiles release is delayed. Increased plastics content of the d-RDF increases the fractional condensibles yield at the expense of gas yield, and causes a slight increase in the hydrocarbon content of the gas.
引用
收藏
页码:133 / 149
页数:17
相关论文
共 26 条
[1]   LOW-PRESSURE PYROLYSIS OF NEWSPRINT PRODUCT FORMATION [J].
AGRAWAL, RK ;
GANDHI, F ;
MCCLUSKEY, RJ .
JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS, 1984, 6 (03) :325-338
[2]  
AGRAWAL RK, 1986, 15TH ANN N AM THERM
[3]   PRODUCT YIELDS AND KINETICS FROM THE VAPOR-PHASE CRACKING OF WOOD PYROLYSIS TARS [J].
BOROSON, ML ;
HOWARD, JB ;
LONGWELL, JP ;
PETERS, WA .
AICHE JOURNAL, 1989, 35 (01) :120-128
[4]  
BOX GEP, 1978, STATISTICS EXPT
[5]   MODELING AND EXPERIMENTAL-VERIFICATION OF PHYSICAL AND CHEMICAL PROCESSES DURING PYROLYSIS OF A LARGE BIOMASS PARTICLE [J].
CHAN, WCR ;
KELBON, M ;
KRIEGER, BB .
FUEL, 1985, 64 (11) :1505-1513
[6]   SINGLE-PARTICLE BIOMASS PYROLYSIS - CORRELATIONS OF REACTION-PRODUCTS WITH PROCESS CONDITIONS [J].
CHAN, WCR ;
KELBON, M ;
KRIEGERBROCKETT, B .
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH, 1988, 27 (12) :2261-2275
[7]   PYROLYSIS OF POLYVINYL-CHLORIDE) [J].
CHANG, EP ;
SALOVEY, R .
JOURNAL OF POLYMER SCIENCE PART A-POLYMER CHEMISTRY, 1974, 12 (12) :2927-2941
[8]  
Cornell J.A., 1990, EXPT MIXTURES DESIGN, V2nd
[9]   RELEASE RATES OF CONDENSABLES AND TOTAL VOLATILES FROM RAPID DEVOLATILIZATION OF POLYETHYLENE AND POLYSTYRENE [J].
DARIVAKIS, GS ;
HOWARD, JB ;
PETERS, WA .
COMBUSTION SCIENCE AND TECHNOLOGY, 1990, 74 (1-6) :267-281
[10]  
DAUGHERTY KE, 1986, P AM POWER C, V45, P930