EFFECT OF SLIDING FRICTION ON CONTACT STRESSES IN A RECTANGLE COMPRESSED BY RIGID PLANES

被引:7
作者
PRASAD, SN [1 ]
DASGUPTA, S [1 ]
机构
[1] UNIV MISSISSIPPI,DEPT CIVIL ENGN,UNIVERSITY,MS 38677
来源
JOURNAL OF APPLIED MECHANICS-TRANSACTIONS OF THE ASME | 1975年 / 42卷 / 03期
关键词
Coefficient of frictions - Contact areas - Contact Stress - Frictional coefficients - Numerical results - Plane strain compression - Sliding friction - Surface displacement;
D O I
10.1115/1.3423659
中图分类号
O3 [力学];
学科分类号
08 ; 0801 ;
摘要
The plane-strain compression of an elastic rectangle by rigid, rough planes with finite coefficient of friction between the surfaces is considered. The contact area is divided into an inner adhesive region in which the surface displacements are known, surrounded by regions in which the friction is limiting and the displacement parallel to the interface is not known. The remaining set of parallel edges of the rectangle is free from tractions. The problem is formulated in terms of Papkovich-Fadle eigenfunctions which lead to the solution of a set of two integral equations of the second kind. Solution of the integral equations which satisfies the finiteness of stresses at the point which separates the adhesive from the slip zone, determines the extent of adhesion. This is found to be independent of the magnitude of load, but depends on the values of frictional coefficients, Poisson’s ratio and the aspect ratio. Numerical results of the quantities of practical interest are reported. © 1975 by ASME.
引用
收藏
页码:656 / 662
页数:7
相关论文
共 15 条
[1]   PAPKOVICH-FADLE SOLUTIONS OF CRACK PROBLEMS RELATING TO AN ELASTIC STRIP [J].
CHATTERJEE, SN ;
PRASAD, SN .
INTERNATIONAL JOURNAL OF ENGINEERING SCIENCE, 1973, 11 (10) :1079-1101
[2]  
DASGUPTA S, TO BE PUBLISHED
[3]  
DUNDURS J, 1970, T ASME E, V92, P965
[4]  
ERDOGAN F, 1972, METHODS ANALYSIS SOL
[5]  
Freeman N. J., 1967, INT J SOLIDS STRUCT, V3, P799
[6]  
GALIN LA, 1961, CONTACT PROBLEMS THE
[7]  
GOODMAN LE, 1962, T ASME E, V74, P515
[8]  
GRADSHTEYN IS, 1965, TABLE INTEGRALS SERI, P427
[9]  
GUPTA GD, 1973, T ASME, V95, P948
[10]  
KEER LM, 1964, T ASME E, V86, P430