CRUSTAL DEFORMATIONS ASSOCIATED WITH THE 1986 FISSURE ERUPTION OF IZU-OSHIMA VOLCANO, JAPAN, AND THEIR TECTONIC SIGNIFICANCE

We have investigated crustal deformations associated with the 1986 eruption of Izu-Oshima volcano, Japan, which was accompanied by an intensive fissure eruption. Two fissure crater chains, with NW-SE trend were created in the northern part of the caldera and on its northwestern flank. Their trend is consistent with the direction of compressive stress in this region. Depression of > 30 cm in the central zone including the caldera, and in the northwestern and southeastern parts in the island, was detected by precise leveling. On the other hand, uplifts up to 20 cm in the northeastern and southwestern parts were observed. Tide observations revealed that the Okada tide station, the leveling datum in Izu-Oshima, may have subsided by 5 cm after the eruption. An ∼1 m opening of fissure craters was detected by distance measurements of the baselines which cross fissure craters. Horizontal displacements obtained by reoccupation of control points showed a symmetrical pattern which was consistent with the opening of fissure craters. Anomalous strain changes were also observed in the surrounding regions-contractions were observed in the Boso and the Miura peninsula, northeast of Izu-Oshima, and extensions in the Izu peninsula. To interpret these crustal deformations, a model which consists of a nearly vertical tensile fault and a deflation source is presented. The tensile fault lies parallel to the fissures and is divided into two parts according to depth. The deeper part of the tensile fault is 12 km long, 10 km wide, and has 2 km burial depth and 2.7 m opening displacement. The shallower part, which may represent the fissure craters, is 4 km long, 2 km wide, and the amount of opening is estimated to be 1 m. However, the deflation source may be located at a depth of 10 km beneath the northwestern flank of the caldera and depression just above the source is estimated to be 30 cm. A deflation source is required to explain the subsidence at the Okada tide station and the extension in the Izu peninsula. This model suggests that the eruption might have released tensile stresses in and around the Izu region which result from bending of the subducting Philippine Sea plate. © 1990.