MECHANICAL-PROPERTIES OF AMORPHOUS ALLOY COMPACTS PREPARED BY DIFFERENT CONSOLIDATION TECHNIQUES

Amorphous alloy compacts of Fe78B13Si9 prepared by three different techniques (explosive consolidation, high hydrostatic pressure consolidation and warm extrusion) were deformed in compression between 573 and 723 K at a strain rate ranging from 8.3 x 10(-5)-4.2 x 10(-4)S-1. Explosively consolidated compacts had high strength ranging from 1.9-2.5 GPa below 623 K and could be plastically deformed to a strain of more than 50% at 673 K while preserving the amorphous state. Amorphous alloy compacts prepared by high hydrostatic pressure consolidation showed lower compressive strength. Those produced by warm extrusion were anisotropic in strength, the highest strength being as high as 2.74 GPa. It was also found that the geometry of the starting powders had a profound effect on the strength of the product compacts. Compacts prepared from flaky powders were stronger than those prepared from spherical ones. It is concluded that the mechanical properties of the amorphous alloy compacts depend on the consolidation technique, powder geometry and surface conditions of the powders, especially existence of oxide films.