GENERAL CONSEQUENCES OF THE PACKING PHASE IN INJECTION-MOLDING

被引：25

作者：

GREENER, J

机构：

来源：

POLYMER ENGINEERING AND SCIENCE | 1986年 / 26卷 / 12期

关键词：

D O I：

10.1002/pen.760261208

中图分类号：

TQ [化学工业];

学科分类号：

0817 ;

摘要：

引用

收藏

页码：886 / 892

页数：7

相关论文

共 17 条

[1] Carlslaw HS, 1959, CONDUCTION HEAT SOLI
[2] ANALYSIS OF THE PACKING STAGE IN INJECTION-MOLDING OF DISK CAVITIES
CHUNG, TS
IDE, Y
[J]. JOURNAL OF APPLIED POLYMER SCIENCE, 1983, 28 (09) : 2999 - 3002
[3] PRESSURE BUILDUP DURING THE PACKING STAGE OF INJECTION-MOLDING
CHUNG, TS
[J]. POLYMER ENGINEERING AND SCIENCE, 1985, 25 (12) : 772 - 777
[4] ORIENTATION DEVELOPMENT AND RELAXATION IN INJECTION-MOLDING OF AMORPHOUS POLYMERS
DIETZ, W
WHITE, JL
CLARK, ES
[J]. POLYMER ENGINEERING AND SCIENCE, 1978, 18 (04) : 273 - 281
[5] PRESSURE-INDUCED DENSIFICATION IN INJECTION-MOLDING
GREENER, J
[J]. POLYMER ENGINEERING AND SCIENCE, 1986, 26 (08) : 534 - 542
[6] ORIENTATION RESIDUAL-STRESSES AND BIREFRINGENCE IN INJECTION-MOLDING
GREENER, J
PEARSON, GH
[J]. JOURNAL OF RHEOLOGY, 1983, 27 (02) : 115 - 134
[7] INJECTION MOLDING BEHAVIOR OF THERMOPLASTICS IN THIN RECTANGULAR CAVITIES
KAMAL, MR
KUO, Y
DOAN, PH
[J]. POLYMER ENGINEERING AND SCIENCE, 1975, 15 (12) : 863 - 868
[8] INJECTION MOLDING OF THERMOPLASTICS .1. THEORETICAL MODEL
KAMAL, MR
KENIG, S
[J]. POLYMER ENGINEERING AND SCIENCE, 1972, 12 (04) : 294 - &
[9] PACKING AND DISCHARGE IN INJECTION MOLDING
KOITA, YT
[J]. POLYMER ENGINEERING AND SCIENCE, 1974, 14 (12) : 840 - 847
[10] MIDDLEMAN S, 1977, FUNDAMENTALS POLYM P, pCH11