ENHANCED EJECTOR REFRIGERATION CYCLES POWERED BY LOW-GRADE HEAT .2. DESIGN PROCEDURES

被引：52

作者：

SOKOLOV, M

HERSHGAL, D

机构：

[1] Department of Fluid Mechanics and Heat Transfer, Faculty of Engineering, Tel Aviv University, Ramat Aviv

来源：

INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID | 1990年 / 13卷 / 06期

关键词：

design procedures; ejector refrigeration cycle; low grade heat;

D O I：

10.1016/0140-7007(90)90024-Q

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

In Part 1 of this work, the conventional and compression enhanced ejector refrigeration cycles were discussed from a thermodynamic and conceptual point of view. This paper describes the development of procedures which will enable system design, optimization and control of operation. Special attention is given to the ejector design and the recommended modification of conventional system components such as the evaporator and generator. A multi-ejector system is introduced in order to expand the range in which the system may operate efficiently. © 1990.

引用

页码：357 / 363

页数：7

共 5 条

[1]

Sokolov, Hershgal, Enhanced ejector refrigeration cycles powered by low grade heat. Part 1. Systems characterization, Int J Refrig, 13, pp. 351-356, (1990)

[2]

Sokolov, Hershgal, Enhanced ejector refrigeration cycles powered by low grade heat. Part 3. Experimental results, Int J Refrig, (1990)

[3]

Keenan, Neumann, Lustuerk, An investigation of ejector design by analysis and experiment, J Appl Mech Trans ASME, pp. 299-309, (1950)

[4]

Paper No. 163 on Supersonic Ejectors: AGARDograph, (1972)

[5]

Zucrow, Hoffman, Gas Dynamics, (1977)

← 1 →