DETERMINATION OF OPTIMAL SUBDIVISION OF DEPTH OF CUT IN MULTIPASS TURNING WITH CONSTRAINTS

被引：83

作者：

GUPTA, R ^{[1
]}

BATRA, JL ^{[1
]}

LAL, GK ^{[1
]}

机构：

[1] INDIAN INST TECHNOL,DEPT MECH ENGN,KANPUR 208016,UTTAR PRADESH,INDIA

来源：

INTERNATIONAL JOURNAL OF PRODUCTION RESEARCH | 1995年 / 33卷 / 09期

关键词：

D O I：

10.1080/00207549508904831

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Optimal subdivision of total depth of cut during cost optimization in multipass turning is an important decision along with the selection of speed and feed. In this paper a new approach for the determination of the optimal subdivision of depth of cut is presented. The total production cost minimization is achieved by summation of the minimum costs of individual rough passes and the finish pass. The cost of each rough pass or finish pass is independently minimized. The optimal subdivision of total depth of cut is obtained using an integer programming model. The resulting subdivision of depth of cut yields a lower minimum cost than that obtained by using the commonly practised strategy of having minimum depth of cut in the finish pass and removing the remaining depth of cut in number of rough passes of equal size.

引用

页码：2555 / 2565

页数：11

共 10 条

[1]

Agapiou J.S., The optimization of machining operations based on a combined criterion, part 2: Multipass operations, Transactions of the ASME Journal of Engineering for Industry, 114, pp. 508-513, (1992)

[2]

Ermer D.S., Optimization of the constrained machining economics problem—by geometric programming, Transactions of the ASME Journal of Engineering for Industry, 93, pp. 1067-1072, (1971)

[3]

Ermer D.S., Kromodihardjo S., Optimization of multipass turning with constraints, Transactions of the ASME Journal of Engineering for Industry, 103, pp. 462-468, (1981)

[4]

Gilbert W.W., Machining Theory and Practice, American Society of Metals, pp. 465-485, (1950)

[5]

Gopalkrishnan B., Faiz A.-K., Machining parameter selection for turning-with constraints: An analytical approach based on geometric programming, International Journal of Production Research, 29, pp. 1897-1908, (1991)

[6]

Hinduja S., Petty D.J., Tester M., Barrow G., Calculation of optimum cutting conditions for turning operations, Proceedings of the Institution of Mechanical Engineers, 199, B2, pp. 81-92, (1995)

[7]

Iwata K., Murotsu Y., Oba F., Optimization of cutting conditions for multipass operations considering probabilistic nature in machining process, Transactions of the ASME Journal of Engineering for Industry, 99, pp. 210-217, (1977)

[8]

Lambert B.K., Walvekar A., Optimization of multipass machining operations, International Journal of Production Research, 16, pp. 259-265, (1978)

[9]

Yellowley I., Gunn E.A., The optimal subdivision of cut in multipass machining operations, International Journal of Production Research, 27, pp. 1573-1578, (1989)

[10]

Shin Y.C., Joo Y.S., Optimization of machining conditions with practical cons taints, International Journal of Production Research, 30, pp. 2907-2919, (1992)

← 1 →