PROPERTIES OF FREE FILMS PREPARED FROM AQUEOUS POLYMERS BY A SPRAYING TECHNIQUE

A spray method for the preparation of free films from aqueous polymeric dispersions was investigated. Free films were prepared from aqueous dispersions of methacrylic acid-ethyl methacrylate copolymer (Eudragit (R) L 30D), hydroxypropyl methylcellulose acetate succinate (HPMCAS), cellulose acetate phthalate (CAP), and ethyl cellulose (EC) by a spray method and a cast method, and their mechanical properties and reproducibility were investigated. Uniform films were obtained from the dispersions of Eudragit (R) L 30D, HPMCAS, and EC by the spray method, but films could not be formed by spraying the CAP dispersion. The tensile strength, elongation, and elastic modulus of the sprayed Eudragit (R) L 30D films were similar to the properties of the cast films, and good reproducibility was obtained from both methods. Marked within-run variation in the mechanical properties was observed for the cast HPMCAS and CAP films, which could be due to a settling of the solid particles during the drying step. The variation in the mechanical properties of the sprayed HPMCAS films was lower and the tensile strength significantly higher than that of the cast films. There were also significant differences in tensile strength and elongation of EC films between products of the two methods. The results indicated that the spray method used to prepare the free films from aqueous polymeric dispersions provided uniform films with consistent and reproducible properties.