GEOMETRY OF THE SEPTEMBER 1971 ERUPTIVE FISSURE AT KILAUEA VOLCANO, HAWAII

被引:4
作者
DVORAK, JJ
机构
[1] Hawaiian Volcano Observatory, U.S. Geological Survey, 96718, Hawaii, Hawaii Volcanoes National Park
关键词
D O I
10.1007/BF00301531
中图分类号
P [天文学、地球科学];
学科分类号
07 ;
摘要
A three-dimensional model has been used to estimate the location and dimensions of the eruptive fissure for the 24-29 September 1971 eruption along the southwest rift zone of Kilauea volcano, Hawaii. The model is an inclined rectangular sheet embedded in an elastic half-space with constant displacement on the plane of the sheet. The set of "best" model parameters suggests that the sheet is vertical, extends from a depth of about 2 km to the surface, and has a length of about 14 km. Because this sheet intersects the surface where eruptive vents and extensive ground cracking formed during the eruption, this sheet probably represents the conduit for erupted lava. The amount of displacement perpendicular to the sheet is about 1.9 m, in the middle range of values measured for the amount of opening across the September 1971 eruptive fissure. The thickness of the eruptive fissure associated with the January 1983 east rift zone eruption was determined in an earlier paper to be 3.6 m, about twice the thickness determined here for the September 1971 eruption. Because the lengths (12 km for 1983 and 14 km for 1971) and heights (about 2 km) of the sheet models derived for the January 1983 and September 1971 rift zone eruptions are nearly identical, the greater thickness for the January 1983 eruptive fissure implies that the magma pressure was about a factor of two greater to form the January 1983 eruptive fissure. Because the September 1971 and January 1983 eruptive fissures extent to depths of only a few kilometers, the region of greatest compressive stress produced along the volcano's flank by either of these eruptive fissures would also be within a few kilometers of the surface. Previous work has shown that rift eruptions and intrusions contribute to the buildup of compressive stress along Kilauea's south flank and that this buildup is released by increased seismicity along the south flank. Because south flank earthquakes occur at significantly greater depths, i.e., from 5 to 13 km, than the vertical extent of the 1971 and 1983 eruptiv fissures, the depth of emplacement of these eruptive fissures cannot be the main factor in controlling the hypocentral depths of south flank earthquakes. Two possible explanations for the occurrence of south flank earthquakes in the depth range of 5-13 km are (1) a deeper pressure source, possibly related to deeper magma storage within the rift zone, and (2) a lowstrength region located between 5 and 13 km beneath Kilauea's south flank, possibly at the interface between oceanic sediments and the base of the Hawaiian volcanics. © 1990 Springer-Verlag.
引用
收藏
页码:507 / 514
页数:8
相关论文
共 20 条
[1]  
Davis P.M., Surface deformation associated with a dipping hydrofracture, J Geophys Res, 88, pp. 5826-5834, (1983)
[2]  
Dieterich J.H., Decker R.W., Finite element modeling of surface deformation associated with volcanism, Journal of Geophysical Research, 80, pp. 4094-4102, (1975)
[3]  
Duffield W.A., Christiansen R.L., Koyangi R.Y., Peterson D.W., Storage, migration, and eruption of magma at Kilauea Volcano, Hawaii, 1971–1972, J Volc Geotherm Res, 13, pp. 273-307, (1982)
[4]  
Dvorak J., Okamura A., Variations in tilt rate and harmonic tremor amplitude during the January-August 1983 east rift eruptions of Kilauea Volcano, Hawaii, J Volc Geotherm Res, 25, pp. 249-258, (1985)
[5]  
Dvorak J., Okamura A., Dieterich J.H., Analysis of surface deformation data, Kilauea Volcano, Hawaii: October 1966 to September 1970, J Geophys Res, 88, pp. 9295-9304, (1983)
[6]  
Dvorak J., Okamura A., English T.T., Koyanagi R.Y., Nakata J.S., Sako M.K., Tanigawa W.T., Yamashita K.M., Mechanical response of the south flank of Kilauea Volcano, Hawaii, to intrusive events along the rift systems, Tecnophysics, 124, pp. 193-209, (1985)
[7]  
Dzurisin D., Koyanagi R.Y., English T.T., Magma supply and storage at Kilauea Volcano, Hawaii: 1956–1983, J Volc Geotherm Res, 21, pp. 177-206, (1984)
[8]  
Eaton J.P., Crustal structure and volcanism in Hawaii, Am Geophys Union Monograph, 6, pp. 13-29, (1962)
[9]  
Eaton J.P., Murata K.J., How volcanoes work, Science, 132, pp. 925-938, (1960)
[10]  
Fiske R.S., Kinoshita W.T., Inflation of Kilauea Volcano prior to the 1967–68 eruption, Science, 165, pp. 341-349, (1969)