CORROSION RATES OF LEAD BASED ANODES FOR ZINC ELECTROWINNING AT HIGH-CURRENT DENSITIES

The corrosion rates of anodes made from various lead/silver alloys have been determined during electrolysis in sulphuric acid solution, pure and containing additives, using current densities in the range 2500 to 10000 A m-2. An increase in acid concentration, and in some cases temperature, caused an increase in the corrosion rate. In the absence of manganese in the bath, the corrosion rate was effectively independent of current density in the range studied, whereas in the presence of manganese, the corrosion rate decreased with decreasing current density. The corrosion rates of various calcium, tin and thallium alloys of lead were also determined. The presence of chloride ions in the electrolyte increases the corrosion rate, whereas potassium ions and strontium carbonate have a negligible effect. Pre-treating silver/lead anodes with a solution of acidic potassium fluoride at 500 A m-2 prior to testing markedly decreased the corrosion rate in the presence of manganese, but increased the corrosion rate with manganese absent. The effect of zinc on the corrosion rate in synthetic electrolyte solutions, with and without manganese present, has also been determined for silver/lead alloys at 10000 A m-2. At zinc levels over 1 M, the corrosion rate increased with and without added manganese. As the work has been undertaken in an attempt to improve the electrowinning of zinc, an electrolyte based on acidified industrial solution has also been tested. The rates observed were similar to those obtained for synthetic zinc-containing solutions.