COMPARATIVE TRIBOLOGY STUDIES OF HARD CERAMIC AND COMPOSITE METAL-DLC COATINGS IN SLIDING FRICTION CONDITIONS

被引：43

作者：

VOEVODIN, AA ^{[1
]}

REBHOLZ, C ^{[1
]}

MATTHEWS, A ^{[1
]}

机构：

[1] UNIV HULL,SURFACE ENGN RES CTR,KINGSTON HULL HU6 7RX,N HUMBERSIDE,ENGLAND

来源：

TRIBOLOGY TRANSACTIONS | 1995年 / 38卷 / 04期

基金：

英国工程与自然科学研究理事会;

关键词：

UNLUBRICATED WEAR REGIME; SURFACE FILMS COATINGS; CERAMICS; DIAMOND; CARBON COMPOSITES;

D O I：

10.1080/10402009508983476

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

The design of anti-friction coatings able to perform well in different wear conditions without lubricants requires a combination of adequate hardness and toughness, good adhesion, a low friction coefficient and a low ear rate. Recently introduced metal-diamond-like carbon (DLC) coating scan be a major step towards the achievement of such combination. These coatings consist of an amorphous a:CH matrix with the possible incorporation of metal, metal carbide and/or graphite grains. Previous studies of Ti-x%-DLC coatings deposited on Ti-TiN-TiCN-TiC supporting interlayers showed their good protective properties against abrasive, impact and single scratch wear. Here, ball-on-disk experiments are carried out to investigate these coatings in conditions of sliding wear against steel and WC balls. A comparison of the results for Ti-x%-DLC and ceramic TiN, TiCN and CrN coatings shows particularly low friction coefficients (below 0.2) and low normalized wear rates for the Ti-x%-DLC coatings. The results reveal a correlation between the tribological properties of these coatings and the amount of the metal component in their matrix; the Ti-35%-DLC and Ti-20%-DLC are recommended for sliding wear applications.

引用

页码：829 / 836

页数：8

共 14 条

[1]

BACHMANN PK, 1992, 2ND P EUR C DIAM DIA

[2] PREPARATION OF W-C-H COATINGS BY REACTIVE MAGNETRON SPUTTERING [J].

BEWILOGUA, K ;

DIMIGEN, H .

SURFACE & COATINGS TECHNOLOGY, 1993, 61 (1-3) :144-150

[3]

BHUSHAN B, 1991, HDB TRIBOLOGY MATERI

[4] MICROSTRUCTURE AND WEAR BEHAVIOR OF METAL-CONTAINING DIAMOND-LIKE COATINGS [J].

DIMIGEN, H ;

KLAGES, CP .

SURFACE & COATINGS TECHNOLOGY, 1991, 49 (1-3) :543-547

[5]

DONLEY MS, 1994, TRIBOLOGICAL COATING, P431

[6] POSSIBILITIES OF MODEL WEAR TESTING FOR THE PRESELECTION OF HARD COATINGS FOR CUTTING TOOLS [J].

HABIG, KH ;

KOCKER, GMZ .

SURFACE & COATINGS TECHNOLOGY, 1993, 62 (1-3) :428-437

[7]

Holmberg K., 1994, COATINGS TRIBOLOGY P

[8]

HOLMBERG K, 1993, TRIBOLOGIA FINNISH J, V12

[9] ENGINEERING APPLICATIONS FOR DIAMOND-LIKE CARBON [J].

MATTHEWS, A ;

ESKILDSEN, SS .

[10] MECHANICAL-PROPERTIES AND STRUCTURE OF DIAMOND-LIKE CARBON [J].

ROBERTSON, J .

← 1 2 →