THE KARST SYSTEM OF THE FONTAINE-DE-VAUCLUSE (SOUTHEASTERN FRANCE)

The intake area of the Fontaine de Vaucluse system covers over 1,100 km2; its mean altitude is 870 m. The Lower Cretaceous limestones (1,500 m thick) give the system a very thick (800 m) unsaturated zone. Karstification is very well developed, both on the intake area (four sinkholes are more than 500 m deep) and on the lower part (sunken cave of 300 m depth under the spring). The bottoms of the sinkholes of the plateau do not reach the saturated zone of the karst, as their flows have chemical composition similar to seepage water. The maximum hydraulic gradient between the plateau and the spring is low, only 0.3%. Dye tracings allow assigning the Ventoux-Lure range (including its calcareous northern side with a southward dipping) and the Vaucluse Plateau to the intake area. The moisture balance, calculated for each altitude belt, shows that the effective rainfall strongly increases with altitude: 120 mm below 200 m, 1,300 mm over 1,800 m. The working of the system, studied by means of discharge, physical and chemical content, is one of a well-karstified milieu that reacts with a light inertia upon rainy periods. The system is made up of important reserves, peculiarly within the unsaturated zone, which maintain long decline and depletion episodes. Despite its large average discharge (21 m3.sec-1), the spring is not harnessed and thus no general protection exists on the intake area. Only local protection is provided by protection areas around some piped little springs of the plateau. A Biosphere Preserve will protect as a whole the higher part of the intake area-Mount Ventoux.