SELF POTENTIAL GENERATED BY 2-PHASE FLOW IN A POROUS-MEDIUM - EXPERIMENTAL-STUDY AND VOLCANOLOGICAL APPLICATIONS

In order to characterize the relationships between self-potential generation and hydrothermal convection, laboratory measurements of electric potential and temperature are made along a vertical cylindrical column of porous material where a two-phase flow (wet steam) occurs. For steady state convection, the vertical distributions of vapor and water flow rates are calculated from thermal balance. At the initiation of convection, a positive electrical charge flux is related to the convective front. For isothermal and steady state columns, a positive electric potential gradient is observed along the vapor flow direction. These electric potentials are mainly a function of the vapor flow rates and of the medium permeability. A sudden and large increase in the vapor flow rate and in the volume fraction of vapor can induce a large and long-lived increase in the potential differences along the vapor flow direction. An electrokinetic effect related to the saturated vapor flow is the best candidate for this electric potential generation. The experimental results obtained in the present study are applied to self-potential generation in rising two-phase convective cells on active volcanoes. The observed positive self-potential anomalies close to active fissures depend on the electrical charge flux related to the upward saturated vapor flow. These results also demonstrate the value of self-potential monitoring in the early stages preceding a volcanic eruption.