ANTITHROMBIN ACTIVITY OF SURFACE-BOUND HEPARIN STUDIED UNDER FLOW CONDITIONS

Polyacrylamide-grafted polyetherurethane sheets were modified by end-point and multipoint attachment of heparin. The surface-bound heparin was firmly attached. No release of heparin activity could be detected when the surface was rinsed at a wall shear rate of 2000 s(-1). Uptake of antithrombin and thrombin inactivation were investigated under well-defined flow conditions by the use of a spinning device with an attached disk-shaped heparinized surface. It is demonstrated that the rate of thrombin inactivation at the antithrombin-heparin surface equals the maximal rate of transport of thrombin toward the surface when the surface coverage of antithrombin exceeds 10 pmol/cm(2). This result indicates that a higher intrinsic catalytic efficiency of a surface does not necessarily result in a higher antithrombin activity. We varied the heparin content of the surfaces between 0 and 35 mu g/cm(2) by increasing the number of functional groups to which heparin could be covalently attached. The uptake of antithrombin increased with the heparin content of the surface, but the stoichiometry decreased from 2 to 0.5 pmol antithrombin/mu g heparin. Apparently, antithrombin could not bind to heparins buried in the poly(acrylamide) layer. The rate of thrombin inactivation at surfaces with low heparin content (2 mu g/cm(2)) fells below the transport limit of thrombin and became proportional with the heparin content of the surface. Although the contribution of surface-bound heparin to the neutralization of fluid-phase thrombin was found to be negligible compared with the effect of fluid-phase antithrombin at physiologic relevant concentrations, these heparinized surfaces markedly delayed the onset of thrombin generation in platelet-rich plasma. It is concluded that the inhibition of locally produced thrombin might contribute to the thromboresistance of the heparinized surface. (C) 1995 John Wiley & Sons, Inc.