ANALYSIS OF THE SINGLE-FIBER PULL-OUT TEST BY MEANS OF RAMAN-SPECTROSCOPY .2. MICROMECHANICS OF DEFORMATION FOR AN ARAMID/EPOXY SYSTEM

The single-fibre pull-out test has been analysed for Kevlar-49 fibres in a cold-cured epoxy resin by using bath a conventional pull-our experiment and Raman spectroscopy. The interfacial shear strength (ISS) has been estimated from the pull-out force for fibres with a range of embedded lengths. Raman spectroscopy has been used to analyse the distribution of fibre strain in the pull-out test by mapping the variation of strain along an aramid fibre undergoing pull-our from the epoxy resin matrix. At low strains the behaviour follows elastic shear-lag analysis bur, as the fibre strain is increased, debonding takes place at the fibre/matrix interface. It is found that this debond propagates along the interface until the entire fibre is debonded The fibre is then pulled out of the resin matrix by a frictional pull-out process. It is shown that the conventional pull-out experiment produces only an apparent value of ISS and that through a partial-debonding model it is possible to use the interfacial parameters obtained from the Raman analysis to predict the data from the conventional test.