FACTORS INFLUENCING THE FORMATION OF ELONGATED MORPHOLOGIES IN IMMISCIBLE POLYMER BLENDS DURING MELT PROCESSING

The morphology of the dispersed phase in immiscible polymer blends plays an important role in the determination of the final physical properties. This paper considers factors that influence the final state of deformation of the dispersed phase, and in particular, the formation of fibers and lamellae. Blends of polyethylene and nylon-6 were extruded by ribbon extrusion at different draw ratios. Prior to single-screw extrusion the materials were blended in a co-rotating twin-screw extruder, and the size of the dispersed phase was studied as a function of the viscosity ratio. As the blends are extruded into ribbons and drawn through the calender rolls, the morphology of the dispersed phase undergoes drastic transformations. The fiber formation is enhanced by increasing the draw ratio. At high draw ratios, long thin fibers are observed. Some biaxial deformation is obtained for the noncompatibilized systems when the extruded materials enter the calender with the maximum closing pressure applied to the rolls. The same effect is observed for the compatibilized systems with lower values of the viscosity ratio. As a general rule, it has been observed that the final dispersed phase deformation is diminished in interfacially compatibilized systems.