EFFECTS OF DENSITY RATIO ON THE HYDRODYNAMICS OF FILM COOLING

被引：170

作者：

PIETRZYK, JR

BOGARD, DG

CRAWFORD, ME

机构：

[1] Mechanical Engineering Department, The University of Texas at Austin, Austin, TX

来源：

JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME | 1990年 / 112卷 / 03期

关键词：

D O I：

10.1115/1.2927678

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 [机械工程];

摘要：

This paper presents the results of a detailed hydrodynamic study of a row of inclined jets issuing into a crossflow with a density ratio of injectant to free stream of 2. Laser-Doppler anemometry was used to measure the vertical and streamwise components of velocity for a jet-to-free stream mass flux ratio of 0.5. Mean velocity components and turbulent Reynolds normal and shear stress components were measured at locations in a vertical plane along the centerline of the jet from 1 diameter upstream to 30 diameters downstream of the jet. The results, which have application to film cooling, give a quantitative picture of the entire flow field, from the approaching flow upstream of the jet, through the interaction region of the jet and free stream, to the relaxation region downstream where the flow field approaches that of a standard turbulent boundary layer. © 1990 by ASME.

引用

页码：437 / 443

页数：7

共 12 条

[1]

Etheridge D., Kemp P., Measurements of Turbulent Flow Downstream of a Rearward-Facing Step, Journal of Fluid Mechanics, 86, pp. 545-566, (1978)

[2]

Edwards R.W., Report of the Special Panel on Statistical Particle Bias Problems in Laser Anemometry, ASME, Journal of Fluids Engineering, 109, pp. 89-93, (1987)

[3]

Foster N.W., Lampard D., Effects of Density and Velocity Ratio on Discrete Hole Film Cooling, AIAA Journal, 13, pp. 1112-1114, (1975)

[4]

Foster N.W., Lampard D., The Flow and Film Cooling Effectiveness Following Injection through a Row of Holes, ASME, Journal of Engineering for Power, 102, pp. 584-588, (1980)

[5]

Launder B.E., York J., Discrete-Hole Cooling in the Presence of Free Stream Turbulence and Strong Favourable Pressure Gradient, International Journal of Heat and Mass Transfer, 17, pp. 1403-1409, (1974)

[6]

Le Brocq P.V., Launder B.E., Priddin C.H., Discrete Hole Injection as a Means of Transpiration Cooling

[7]

An Experimental Study, Proceedings of the Institution of Mechanical Engineers, 187, pp. 149-157, (1973)

[8]

Pedersen D.R., Eckert E.R.G., Goldstein R.J., Film Cooling With Large Density Differences Between the Mainstream and the Secondary Fluid Measured by the Heat-Mass Transfer Analogy, ASME, Journal of Heat Transfer, 99, pp. 620-627, (1977)

[9]

Pietrzyk J.R., Bogard D.G., Crawford M.E., Hydrodynamic Measurements of Jets in Crossflow for Gas Turbine Film Cooling Application, ASME Journal of Turbomachinery, 3, pp. 139-145, (1989)

[10]

Simpson R., Chew Y., Shivaprasad B., The Structure of a Separating Turbulent Boundary Layer. Part 1. Mean Flow and Reynolds Stresses, Journal of Fluid Mechanics, 113, pp. 23-51, (1981)

← 1 2 →