IN-PROCESS DIMENSIONAL CONTROL OF THE WORKPIECE DURING TURNING

被引：19

作者：

FAN, KC

CHAO, YH

机构：

[1] Department of Mechanical Engineering, National Taiwan University, Taipei

来源：

PRECISION ENGINEERING-JOURNAL OF THE AMERICAN SOCIETY FOR PRECISION ENGINEERING | 1991年 / 13卷 / 01期

关键词：

IN-PROCESS MEASUREMENT; COMPENSATION; TURNING; NC CONTROLLER;

D O I：

10.1016/0141-6359(91)90218-8

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This paper presents a newly developed in-process workpiece dimensional measurement and error compensation technique for NC lathes. During operation, the diameter of the workpiece at the cutting point can be obtained through three servo measurement units. Each unit is composed of a non-contact proximitor for direct gap sensing, a stepping motor controlled linear carriage to move the proximitor for surface tracing, and a LVDT for position feedback of the carriage. The error compensation strategy is implemented by interrupting a compensator in the position feedback loop of the NC servo system so that the tool position can be directly controlled by an external personal computer. Experimental results show that the accuracy of the workpiece can be maintained within reasonable tolerance regardless of the length and shape being machined.

引用

页码：27 / 32

页数：6

共 9 条

[1]

Shiraishi, Scope of in-process measurement, monitoring and control techniques in machining process - Part 2: In-process techniques for workpieces, Precision Engng, 11, 1, pp. 27-37, (1989)

[2]

Kohno, Et al., In-process measurement and a workpiece-referred form accuracy control system (WORFAC): Concept of the method and preliminary experiment, Precision Engng, 11, 1, pp. 9-18, (1989)

[3]

Park, Eman, Wu, An in-process flatness error measurement and compensatory control system, Journal of Engineering for Industry, 110, pp. 263-270, (1988)

[4]

Liao, Et al., Development of a Workpiece Straightness Error Compensation System for NC Turning, Proc 27th Int Matador Conf, pp. 187-196, (1988)

[5]

Fan, Et al., Development of a Simple, Low Cost and Portable Compensator for CNC Controllers, Proc 27th Int Matador Conf, pp. 217-224, (1988)

[6]

Koren, Design of computer control for manufacturing system, ASME Trans J Eng Industry, 101, pp. 326-331, (1979)

[7]

Huang, In-Process Control of Turning Process, MSc Thesis, (1987)

[8]

Maltby, Marten, Software of a Computer Numerical Control System Designed for Adaptive Control Research, Proc 19th Int MTDR Conf., pp. 19-26, (1979)

[9]

Koren, Masery, Adaptive control with process estimation, Ann CIRP, 30, pp. 373-376, (1981)

← 1 →