AN EXPERIMENTAL-STUDY OF MULTIPLE GRAIN-SIZE EJECTA PRODUCED BY COLLISIONS OF SALTATING GRAINS WITH A FLAT BED

被引:164
作者
RICE, MA
WILLETTS, BB
MCEWAN, IK
机构
[1] Engineering Department, Aberdeen University, Aberdeen
关键词
D O I
10.1111/j.1365-3091.1995.tb00401.x
中图分类号
P5 [地质学];
学科分类号
0709 ; 081803 ;
摘要
Collision data are presented from coloured high-speed films of three size fractions of sand grains saltating over a bed of the total grain population. Each fraction was colour tagged and the proportion of each size ejected by grains colliding with the surface was recorded on a number of films taken as the bed was progressively eroded. The results confirm earlier findings that V-3/V-1 congruent to 0 . 5-0 . 6, V-n/V-1 congruent to 0 . 08 and the rebound angle increases with decreasing grain size. Ejected grains are examined in relation to their size, the impactor size, ejection speed and angle and the number of ejecta per collision. In addition, changes in grain parameters are observed with time. For fine impacters, ejection speeds generally increase with a decrease in ejecta size, but the fine fraction does not follow this trend for the coarse and medium impacters. Ejection angles are typically between 40 degrees and 60 degrees, with coarse grains having shallower mean angles than fine ejecta. The number of ejections per collision increases with a decrease in particle size for each impactor size. The general tendency for coarse particles to be ejected at lower speeds and shallower angles than fine particles will lead to sorting of the grain sizes. There is poor correlation between the forward momentum loss of the saltating grains at collision and bath the forward momentum of the ejected grains and the number of ejected grains. Much of the forward momentum of the saltating grains is transfered to creeping grains. The composition and geometry of the bed are considered to be important factors in the evolution of the saltation cloud.
引用
收藏
页码:695 / 706
页数:12
相关论文
共 16 条
[1]  
Anderson R.S., Bunas K.L., Grain size segregation and atratigraphy in aeolian ripples modelled with a cellular automaton, Nature, 365, pp. 740-743, (1993)
[2]  
Anderson R.S., Haff P.K., Simulation of eolian saltation, Science, 241, pp. 820-823, (1988)
[3]  
Anderson R.S., Haff P.K., Wind modification and bed‐response during saltation of sand in air, Acta Mech. (Suppl.), 1, pp. 21-51, (1991)
[4]  
Anderson R.S., Hallet B., Sediment transport by wind: toward a general model, Bull. geol. Soc. Am, 97, pp. 523-535, (1986)
[5]  
Haff P.K., Anderson R.S., Grain scale simulations of loose sedimentary beds: the example of grain‐bed impacts in aeolian saltation, Sedimentology, 40, pp. 175-198, (1993)
[6]  
Jensen J.L., Sorensen M., Estimation of some aeolian saltation transport parameters: a re‐analysis of Williams' data, Sedimentology, 33, pp. 547-558, (1986)
[7]  
McEwan I.K., Willetts B.B., Numerical model of the saltation cloud, Acta Mech. (Suppl.), 1, pp. 53-66, (1991)
[8]  
McEwan I.K., Willetts B.B., Sand transport by wind: a review of the current conceptual model, Spec. Publ. geol. Soc, 72, pp. 7-16, (1993)
[9]  
Sorensen M., Estimation of some aeolian saltation transport parameters from transport rate profiles, Proc. Int. Workshop on the Physics of Blown Sand, pp. 141-190, (1985)
[10]  
Sorensen M., An analytic model of wind‐blown sand transport, Acta Mech. (Suppl.), 1, pp. 67-81, (1991)