STUDIES OF THE DEGRADATION OF METAL ADHESIVE INTERFACES WITH SURFACE-ANALYSIS TECHNIQUES

The application of bonded repairs and reinforcements to aircraft components places an emphasis on adherend surface treatment procedures because these treatments can significantly change bond strength and durability. A typical minimum treatment sequence for Alclad 2024-T3 aluminium alloy adherends includes a solvent degrease, an abrasion with a Scotchbrite(R) pad, a clean with a methyl-ethyl-ketone (MEK) soaked tissue and a grit-blast with 45 mum alumina powder. The adherends are treated with gamma-glycidoxy-propyl-trimethoxy-silane (gamma-GPTS) coupling agent then bonded with an epoxy film adhesive. The composition of the adherent, the bond durability and the locus of fracture were examined at several stages of the adherent surface treatment. Boeing wedge tests show that grit-blasting the adherends creates a more durable adhesive bond than the Scotchbrite(R)/MEK treatment and that the application of gamma-GPTS improves bond durability in both cases. XPS has shown that the cleaning sequence decreases the concentration of hydrocarbon contaminant on the grit-blasted adherend to an average thickness of less than 1.5 nm. XPS analyses of the fracture surfaces indicates that for the grit-blast, grit-blast plus gamma-GPTS and Scotchbrite(R)/MEK plus gamma-GPTS treatments, failure occurs primarily in the oxide film, whereas for the Scotchbrite(R)/MEK treatment failure occurs at the adhesive/oxide interface possibly due to weakness induced by contaminant. XPS measurements show that a gamma-GPTS overlayer retards the growth of the oxide on aluminium in humid air, until the gamma-GPTS overlayer is desorbed. The improved bond durability with the coupling agent may be due to the inhibition of hydration sites on this oxide surface.