CREEP AND CREEP FRACTURE IN HOT-PRESSED ALUMINA

The creep and creep fracture behavior of two hot-pressed aluminas are presented, for both flexural and tensile testing. Steady-state power-law creep is observed with a stress exponent of about 2 for each material. Three distinct fracture regimes are found. At high stress in flexure, fracture occurs by slow crack growth with a high stress dependence of the failure time. At intermediate stresses, in both flexure and tension, creep fracture occurs by multiple microcracking after modest strains. Failure times exhibit a modest stress dependence (stress exponent of 2.5 in tension and 3 in flexure), with a constant failure strain equal to 0.09. The failure times are considerably longer in flexure than in tension, because of the constraint imposed on crack growth by the bending geometry. We conclude that flexure cannot be used for creep lifetime assessment, even in simple, single-phase materials such as Al2O3. At low stresses, in tension, failure also exhibits a modest stress dependence but with a much higher failure strain. The material shows the onset of superplastic behavior.