MECHANICAL FRACTURE-BEHAVIOR OF POLYACETAL AND THERMOPLASTIC POLYURETHANE ELASTOMER TOUGHENED POLYACETAL

Polyacetal (POM) toughening with thermoplastic polyurethane (TPU) elastomer was investigated in terms of Theological, mechanical, and morphological properties. Polyacetal can be effectively toughened by the blending with TPU elastomer and the improvement on toughness is found most significant with TPU content from 20 to 30 percent. POM does fracture in ductile mode under extremely low deformation rate and the ductile‐brittle transition rate is at 0.5 mm/min. The transition rate is increased with the increase of elastomer content. The precrack hysteresis energy is important in dictating the failure mode. The experimental results show the hysteresis energy (under constant load) increases with the increase of elastomer content and the decrease of deformation rate. Greater hysteresis energy results in larger precrack plastic zone size and thus tends to shift the fracture mode from brittle to ductile as the critical size of the plastic zone is reached. The adoption of the slow rate fracture method has the advantages of ranking toughness of very brittle polymeric materials vs. the conventional Izod or Charpy impact method by varying temperatures. FTIR shows significant interaction between POM and TPU which is probably responsible for the TPU elastomer being such an efficient toughening agent for POM. Delamination in the buffer zone between the plane‐strain and the plane‐stress is discovered and the possible mechanism is discussed. Copyright © 1990 Society of Plastics Engineers