ONLINE DETECTION OF TOOL BREAKAGE IN MILLING

被引：4

作者：

TARNG, YS

机构：

[1] Department of Mechanical Engineering and Technology, National Taiwan Institute of Technology, Taipei

来源：

MECHANICAL SYSTEMS AND SIGNAL PROCESSING | 1991年 / 5卷 / 05期

关键词：

D O I：

10.1016/0888-3270(91)90005-P

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

The quasi-mean resultant force has been proven to be very useful for sensing tool breakage in milling. It has been also shown that the quasi-mean resultant force is proportional to the quasi-mean resultant displacement of spindle. Therefore, a system for on-line detection of tool breakage in milling has been developed in this paper by using the difference of the quasi-mean resultant displacement of spindle. The threshold value for tool breakage detection under varying cutting conditions can be determined by a teaching method. Theoretical studies and experimental results in milling operations are presented to support the proposed system for detection of tool breakage in the real-time analysis. © 1991.

引用

页码：389 / 401

页数：13

共 10 条

[1]

Diei, Dornfeld, Acoustic emission from the face milling process—the effect of process variables, Journal of Engineering for Industry, 109, pp. 92-99, (1987)

[2]

Matsushima, Bertok, Sata, In-process detection of tool breakage by monitoring the spindle motor current of a machine tool, Measurement and Control for Batch Manufacturing ASME, pp. 145-153, (1982)

[3]

Lan, Naerheim, In-process detection of tool breakage in milling, Journal of Engineering for Industry, 108, pp. 191-197, (1986)

[4]

Braun, Rotberg, Lenz, Signal processing for single tooth milling monitoring, Mechanical Systems and Signal Processing, 1, pp. 185-196, (1987)

[5]

Altintas, Yellowley, Tlusty, Detection of tool breakage in milling, Journal of Engineering for Industry, 110, pp. 271-277, (1988)

[6]

Altintas, Yellowley, In-process detection of tool failure in milling using cutting force models, Journal of Engineering for Industry, 111, pp. 149-157, (1989)

[7]

Tlusty, Jang, Tarng, Measurements of the milling force over a wide frequency range, 14th NAMRC, pp. 273-280, (1986)

[8]

Tarng, Measurement of the quasi-mean resultant force using the vibrational signal in milling, 6th National Conference on Mechanical Engineering CSME, pp. 1201-1208, (1989)

[9]

Fu, Devor, Kapoor, A mechanistic model for the prediction of the force system in face milling, Journal of Engineering for Industry, 106, pp. 81-88, (1984)

[10]

Tlusty, Livingston, Teng, Nonlinearities in spindle bearings and their effects, Annals of the CIRP, 35, pp. 269-273, (1986)

← 1 →