A CUTTING FORCE MODEL FOR FACE MILLING OPERATIONS

被引：64

作者：

KIM, HS

EHMANN, KF

机构：

[1] Yeungnam University, Kyeungsan City

[2] Mechanical Engineering Department, Northwestern University, Evanston, IL 60208

来源：

INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE | 1993年 / 33卷 / 05期

关键词：

Mathematical models - Cutting tools - Force measurement - Time domain analysis - Frequency domain analysis - Degrees of freedom (mechanics);

D O I：

10.1016/0890-6955(93)90099-G

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

A procedure for the simulation of the static and dynamic cutting forces in face milling is described. For the static force model, the initial position errors of the inserts and the eccentricity of the spindle are taken into consideration as the major factors affecting the variation of the chip cross-section. The structural dynamics model for the multi-tooth oblique cutting operation is assumed as a multi-degrees of freedom spatial system. From the relative displacements of this system, based on the double modulation principle, the dynamic cutting forces were derived and simulated. The simulated forces were subsequently compared to measured forces in the time and frequency domains.

引用

页码：651 / 673

页数：23

共 22 条

[1]

Martellotti, An analysis of the milling process, Trans. ASME, 63, (1941)

[2]

Koenigsberger, Sabberwal, An investigation into the cutting force pulsations during milling operations, Int. J. Mach. Tool Des. Res., 1, (1961)

[3]

Usui, Hirota, Analytical prediction of three-dimensional cutting process, part 1

[4]

basic cutting model and energy approach, Trans ASME J Engng Ind., 100, (1978)

[5]

Lin, Prediction of cutting forces and geometry in oblique machining from flow stress properties and cutting conditions, Int. J. Mach. Tool Des. Res., 18, (1978)

[6]

Kirk, Anand, McKindra, Matrix representation and prediction of three directional cutting forces, Trans ASME J. Engng Ind., 99, (1977)

[7]

Pandey, Shan, Analysis of cutting forces in peripheral and face milling operations, Int. J. Prod. Res., 10, (1972)

[8]

Gygax, Dynamics of single tooth milling, Ann. CIRP, 28, (1979)

[9]

Gygax, Experimental full cutting milling dynamics, CIRP Annals - Manufacturing Technology, 29, (1980)

[10]

Ruzhong, Wang, Modeling of cutting force pulsations in face milling, Ann. CIRP, 32, (1983)

← 1 2 3 →