A CUTTING FORCE MODEL FOR FACE MILLING OPERATIONS

被引：64

作者：

KIM, HS

EHMANN, KF

机构：

[1] Yeungnam University, Kyeungsan City

[2] Mechanical Engineering Department, Northwestern University, Evanston, IL 60208

来源：

INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE | 1993年 / 33卷 / 05期

关键词：

Mathematical models - Cutting tools - Force measurement - Time domain analysis - Frequency domain analysis - Degrees of freedom (mechanics);

D O I：

10.1016/0890-6955(93)90099-G

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

A procedure for the simulation of the static and dynamic cutting forces in face milling is described. For the static force model, the initial position errors of the inserts and the eccentricity of the spindle are taken into consideration as the major factors affecting the variation of the chip cross-section. The structural dynamics model for the multi-tooth oblique cutting operation is assumed as a multi-degrees of freedom spatial system. From the relative displacements of this system, based on the double modulation principle, the dynamic cutting forces were derived and simulated. The simulated forces were subsequently compared to measured forces in the time and frequency domains.

引用

页码：651 / 673

页数：23

共 22 条

[11]

Fu, DeVor, Kapoor, A mechanistic model for prediction of the force system in face milling operations, Trans ASME J. Engng Ind., 106, (1984)

[12]

Kline, DeVor, The effect of run out on cutting geometry and forces in milling, Int. J. Mach. Tool Des. Res., 23, (1983)

[13]

Das, Tobias, The relation between the static and the dynamic cutting of metals, Int. J. Mach. Tool Des. Res., 7, (1967)

[14]

Tlusty, Dynamics of high-speed milling, Journal of Engineering for Industry, 108, (1986)

[15]

Tlusty, Ismail, Special aspects of chatter in milling, Trans ASME J. Vib. Acoust. Stress Reliabil. Des., 105, (1983)

[16]

Tlusty, Moriwaki, Goel, The dynamic cutting force coefficient for some carbon steels, Proc. 4th NAMRC, (1976)

[17]

Doolan, Burney, Wu, Computer design of a multipurpose minimum vibration face milling cutter, Int. J. Mach. Tool Des. Res., 16, (1976)

[18]

Nigm, Sadek, Tobias, Determination of dynamic cutting coefficients from steady state cutting data, Int. J. Mach. Tool Des. Res., 17, (1977)

[19]

Ahn, Eman, Wu, Identification of the transfer function of the dynamic cutting process—A comparative assessment, International Journal of Machine Tool Design and Research, 25, (1986)

[20]

Opitz, Bernardi, Investigation and calculation of the chatter behavior of lathes and milling machines, Ann. CIRP, 17, (1970)

← 1 2 3 →