Adsorption and desorption kinetics of hydrocarbons in FCC catalysts studied using a tapered element oscillating microbalance (TEOM). Part 2: numerical simulations

The factors affecting the adsorption and desorption kinetics in a TEOM are reviewed in detail with particular attention given to the assumptions required to obtain physical transport parameters from the data. Two models are presented to simulate TEOM adsorption data in the case that concentration differences down the catalyst bed can be neglected, as is appropriate when the amount of catalyst used is small, the carrier gas flowrate is large, and/or the adsorbate partial pressure is low. In the first model, the effective diffusion coefficient, D,, is taken to be constant. In the second model, the effective diffusion coefficient is assumed to obey the Darken equation, D-e =D-o/(1 - theta). The TEOM results obtained on n-hexane, n heptane, n-octane, toluene and p-xylene on a commercial FCC catalyst and on pure rare-earth exchanged zeolite Y under non-reacting conditions (373-473 K) are analysed in detail. It is found that intracrystalline diffusion is not the limiting factor affecting the overall rates of adsorption and desorption for the systems studied. Instead, it is the transport of molecules between the adsorbed and vapour phases at the edge of zeolite crystallites that is the limiting transport step affecting the overall kinetics. For the FCC catalyst, the limiting step is the transport of molecules at the zeolite-matrix interface rather than, say, the matrix-vapour interface. Local rate constants for the desorption of the hydrocarbons at the rate-controlling interface have been obtained. (C) 2004 Elsevier Ltd. All rights reserved.