Feasibility of employing permanent chemical modifiers for the determination of cadmium in coal using slurry sampling electrothermal atomic absorption spectrometry

被引:29
作者
Bianchin, L
Nadvorny, D
da Silva, AF
Vale, MGR [1 ]
da Silva, MM
dos Santos, WNL
Ferreira, SLC
Welz, B
Heitmann, U
机构
[1] Univ Fed Rio Grande do Sul, Inst Quim, BR-91501970 Porto Alegre, RS, Brazil
[2] Univ Fed Santa Catarina, Dept Quim, BR-88080900 Florianopolis, SC, Brazil
[3] Univ Fed Bahia, Inst Quim, BR-40170290 Salvador, BA, Brazil
[4] ISAS, Dept Berlin, Inst Analyt Sci, D-12489 Berlin, Germany
关键词
electrothermal atomic absorption spectrometry; slurry sampling; cadmium determination; coal analysis; permanent chemical modifiers; background correction; high-resolution continuum source AAS;
D O I
10.1016/j.microc.2006.01.003
中图分类号
O65 [分析化学];
学科分类号
070302 ; 081704 ;
摘要
Iridium and ruthenium, alone and in combination with tungsten, thermally deposited on the platform of a transversely heated graphite tube, were investigated for their suitability as permanent chemical modifiers for the determination of cadmium in coal slurries by electrothermal atomic absorption spectrometry (ET AAS). The conventional mixed palladium and magnesium nitrates (Pd-Mg) modifiers, added in solution, were also investigated for comparison. The latter one showed the best performance for aqueous solutions, and the mixed W-Ir and W-Ru permanent modifiers had the lowest stabilizing power. All of the investigated modifiers lost some of their stabilizing power when coal slurries were investigated. The Pd-Mg modifier, pure Ir and Ru, and a mixture of 300 mu g W+200 mu g Ir could stabilize Cd at least to a pyrolysis temperature of 600 degrees C, whereas all the other combinations already failed at temperatures above 500-550 degrees C. Additional investigations of the supernatant liquid of the slurries supported the assumption that the high acid concentration of the slurries and/or a concomitant leaching out of the coal might be responsible for the reduced stabilizing power of the modifiers. The maximum applicable pyrolysis temperature of 600 degrees C was not sufficient to reduce the background absorption to a manageable level in the majority of the coal samples. High-resolution continuum source ET AAS revealed that the continuous background absorption was exceeding values of A=2, and was overlapping with the analyte signal. Although the latter technique could correct for this background absorption, some analyte was apparently lost with the rapidly vaporizing matrix so that the method could not be considered to be rugged. A characteristic mass of 1.0 pg and a detection limit of 0.6 ng g(-1) could be obtained under these conditions. (c) 2006 Elsevier B.V. All rights reserved.
引用
收藏
页码:174 / 182
页数:9
相关论文
共 35 条
[31]   Behaviour of selenium(IV) in a transversely heated graphite atomizer for electrothermal atomic absorption spectrometry in the presence of platinum metals as chemical modifiers [J].
Volynsky, AB ;
Krivan, V .
JOURNAL OF ANALYTICAL ATOMIC SPECTROMETRY, 1997, 12 (03) :333-340
[32]  
Welz B, 2005, HIGH-RESOLUTION CONTINUUM SOURCE AAS: THE BETTER WAY TO DO ATOMIC ABSORPTION SPECTROMETRY, P1, DOI 10.1002/3527606513
[33]   PALLADIUM NITRATE MAGNESIUM-NITRATE MODIFIER FOR ELECTROTHERMAL ATOMIC-ABSORPTION SPECTROMETRY .5. PERFORMANCE FOR THE DETERMINATION OF 21 ELEMENTS [J].
WELZ, B ;
SCHLEMMER, G ;
MUDAKAVI, JR .
JOURNAL OF ANALYTICAL ATOMIC SPECTROMETRY, 1992, 7 (08) :1257-1271
[34]  
WELZ B, 1999, ATOMIC ABSORPTION SP, P492
[35]  
ZJUSZZUBEK E, 2003, FUEL, V82, P1281