Enhanced gas permeation performance of polyethersulfone mixed matrix hollow fiber membranes using novel Dynasylan Ameo silane agent

被引:133
作者
Ismail, A. F. [1 ]
Kusworo, T. D. [1 ,2 ]
Mustafa, A. [1 ]
机构
[1] Univ Teknol Malaysia, Membrane Res Unit, Fac Chem & Nat Resources Engn, Skudai 81310, Johor Bahru, Malaysia
[2] Univ Diponegoro, Dept Chem Engn, Jl Prof Sudharto, Tembalang, Indonesia
关键词
gas separation membrane; mixed matrix membrane; amino silane; surface modification;
D O I
10.1016/j.memsci.2008.03.067
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
This study is performed primarily to investigate the effect of chemical modification on zeolite surface towards gas separation performance of hollow fibers mixed matrix membrane. In this study, polyethersulfone (PES)-zeolite 4A mixed matrix hollow fiber membrane for modified and unmodified zeolite was spun using dry/wet spinning technique. The modified zeolite 4A was prepared by treating the zeolite with Dynasylan Ameo (DA) silane agent to allow PES chains to be grafted on zeolite surface. The results from the Field Emission Scanning Electron Microscopy (FESEM), DSC and Fourier transform infrared spectroscopy (FTIR) analysis confirmed that chemical modification on zeolite surface had taken place. 'Sieve-in-a-cage' morphology observed the poor adhesion between polymer and unmodified zeolite. FESEM's cross-section view indicated good compatibility between polymer and zeolite for PES-modified zeolite. The gas separation performance of the mixed matrix hollow fiber membranes with modified zeolite were relatively higher compared to that of the hollow fiber mixed matrix membranes with unmodified zeolite. PES-modified zeolite 20 wt% silane yielded significant selectivity enhancement of 7.26 and 46.28 for O-2/N-2 and CO2/CH4, respectively. (c) 2008 Elsevier B.V. All rights reserved.
引用
收藏
页码:306 / 312
页数:7
相关论文
共 15 条
[1]   Influence of surface modification of fillers and polymer on flammability and tensile behaviour of polypropylene-composites [J].
Demir, H ;
Balköse, D ;
Ülkü, S .
POLYMER DEGRADATION AND STABILITY, 2006, 91 (05) :1079-1085
[2]   PREPARATION OF ZEOLITE FILLED GLASSY POLYMER MEMBRANES [J].
DUVAL, JM ;
KEMPERMAN, AJB ;
FOLKERS, B ;
MULDER, MHV ;
DESGRANDCHAMPS, G ;
SMOLDERS, CA .
JOURNAL OF APPLIED POLYMER SCIENCE, 1994, 54 (04) :409-418
[3]   Carbon molecular sieve membranes derived from thermally labile polymer containing blend polymers and their gas separation properties [J].
Kim, YK ;
Park, HB ;
Lee, YM .
JOURNAL OF MEMBRANE SCIENCE, 2004, 243 (1-2) :9-17
[4]   Dependence of membrane morphology and performance on preparation conditions: The shear rate effect in membrane casting [J].
Kusworo, T. D. ;
Ismail, A. F. ;
Mustafa, A. ;
Matsuura, T. .
SEPARATION AND PURIFICATION TECHNOLOGY, 2008, 61 (03) :249-257
[5]   Effects of novel silane modification of zeolite surface on polymer chain rigidification and partial pore blockage in polyethersulfone (PES)-zeolite A mixed matrix membranes [J].
Li, Y ;
Guan, HM ;
Chung, TS ;
Kulprathipanja, S .
JOURNAL OF MEMBRANE SCIENCE, 2006, 275 (1-2) :17-28
[6]   The effects of polymer chain rigidification, zeolite pore size and pore blockage on polyethersulfone (PES)-zeolite A mixed matrix membranes [J].
Li, Y ;
Chung, TS ;
Cao, C ;
Kulprathipanja, S .
JOURNAL OF MEMBRANE SCIENCE, 2005, 260 (1-2) :45-55
[7]   Factors controlling successful formation of mixed-matrix gas separation materials [J].
Mahajan, R ;
Koros, WJ .
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH, 2000, 39 (08) :2692-2696
[8]  
Pechar T. W., 2006, J MEMBRANE SCI, V277, P46
[9]   Effect of carbon molecular sieve sizing with poly(vinyl pyrrolidone) K-15 on carbon molecular sieve-polysulfone mixed matrix membrane [J].
Rafizah, W. A. W. ;
Ismail, A. F. .
JOURNAL OF MEMBRANE SCIENCE, 2008, 307 (01) :53-61
[10]   GAS PERMEATION CHARACTERISTICS OF POLYMER-ZEOLITE MIXED MATRIX MEMBRANES [J].
SUER, MG ;
BAC, N ;
YILMAZ, L .
JOURNAL OF MEMBRANE SCIENCE, 1994, 91 (1-2) :77-86