In situ cure monitoring of epoxy resins using optical fibre sensors

This paper describes a comparative study of in situ cure monitoring by three methods: (i) evanescent wave spectroscopy; (ii) refractive index change; and (iii) near-infrared spectroscopy. The cure characteristics of an epoxy/amine reaction were followed in real-time during the crosslinking reaction via the above-mentioned techniques. The evanescent wave spectroscopy technique was based on monitoring the characteristic infrared absorption bands of the resin system to compute the concentration of the amine hardener as a function of cure time. Good correlation was obtained between the evanescent wave spectroscopy data and a conventional method of studying cure reactions, i.e. infrared spectroscopy. During the cure reaction, the refractive index of the resin system increases as a function of the crosslink density. This increase in the refractive index was monitored using two optical fibre techniques. In the first case, a declad region of the optical fibre was immersed in the resin system and in the second method an optical fibre reflectometer was used to track the changes in the refractive index. Once again, good correlation was obtained between the optical fibre techniques and infrared spectroscopy cure data. The results obtained from the optical fibre sensor experiments were used to model the cure kinetics of the resin system. The cure kinetic models were found to predict the cure reaction up to approximately 60% of the reaction.