Co-continuous polycarbonate/ABS blends

Co-continuous PC/ABS (50150) blends were studied with a variable polybutadiene (PB) content (0-40%) in ABS. Polycarbonate (PC), styrene-acrylonitrile (SAN) and PB were blended in two steps using a twin screw extruder. Rectangular bars were injection moulded and notched Izod impact tested at different temperatures and in single edge notch tensile tests at I m/s and different temperatures. Co-continuous PC/ABS gave a brittle-to-ductile transition temperature lower than expected based on notched Izod results for dispersed ABS in PC. The brittle-to-ductile transition temperature, in the co-continuous PC/ABS blends, decreased with increasing rubber content in SAN. The fracture energies showed an optimum at 15% PB in SAN while at the same time a delamination was seen on the ductile fracture surface, due to failure of the PC/SAN interface. Delamination disappeared when the rubber content in SAN or the temperature was increased. Specimens containing a welding were injection moulded to study the influence of rubber and AN content in the SAN on the interface. Weldline strength of the blends was very poor compared to PC, but improved with increasing rubber content in SAN. (C) 2002 Elsevier Science Ltd. All rights reserved.