Modelling the interaction of bentonite with hyperalkaline fluids

Many designs for geological disposal facilities for radioactive and toxic wastes envisage the use of cement together with bentonite clay as engineered barriers. However, there are concerns that the mineralogical composition of the bentonite will not be stable under the hyperalkaline pore fluid conditions (pH > 12) typical of cement and its properties will degrade over long time periods. The possible extent of reaction between bentonite and cement pore fluids was simulated using the reaction-transport model, PRECIP. Key minerals in the bentonite (Na-montmorillonite, analcite, chalcedony, quartz, calcite) were allowed to dissolve and precipitate using kinetic (time-dependent) reaction mechanisms. Simulations were carried out with different model variants investigating the effects of: temperature (25 and 70 C); cement pore fluid composition; dissolution mechanism of montmorillonite; rates of growth of product minerals; solubilities of product minerals; and aqueous speciation of Si at high pH. Simulations were run for a maximum of 3.2 ka. The results of all simulations showed complex fronts of mineral dissolution and growth, driven by the relative rates of these processes for different minerals. Calcium silicate hydrate (CSH) minerals formed closest to the cement-bentonite boundary, whereas zeolites and sheet silicates formed further away. Some growth of primary bentonite minerals (analcite, chalcedony, calcite and montmorillonite) was observed under certain conditions. Most alteration was associated with the fluid of highest pH, which showed total removal of primary bentonite minerals up to 60 cm from the contact with cement after similar to 1 ka. The maximum porosity increase observed was up to 80-90% over a narrow zone 1-2 cm wide, close to the cement pore fluid- bentonite contact. All simulations (except that with alternative aqueous speciation data for Si) showed total filling of porosity a few crass beyond this interface with the cement, which occurred after a maximum of 3.2 ka. Porosity occlusion was principally a function of the growth of CSH minerals such as tobermorite. There was very little difference in the alteration attained using different model variants, suggesting that bentonite alteration was not sensitive to the changes in parameters under the conditions studied, so that transport of pore fluid through the bentonite governed the amount of alteration predicted. Principal remaining uncertainties associated with the modelling relate to assumptions concerning the evolution of surface areas of minerals with time, and the synergy between changing porosity and fluid flow/diffusion. (C) 2002 Elsevier Science Ltd. All rights reserved.