A multi-step lubricant evaluation strategy for wire drawing-extrusion-cold heading sequence

被引：15

作者：

Dubois, A ^{[1
]}

Lazzarotto, L

Dubar, L

Oudin, J

机构：

[1] Univ Valencia, LAMIH, LGM, F-59313 Valence 9, France

[2] Ctr Tech Ind Mecan, F-42952 St Etienne Du Rouvray 9, France

来源：

WEAR | 2001年 / 249卷 / 10-11期

关键词：

wire drawing; extrusion; cold heading;

D O I：

10.1016/S0043-1648(01)00830-4

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

The upsetting-sliding, test was used to simulate the characteristic contact conditions of a cold heading sequence comprising two operations, wire drawing and direct extrusion. Friction conditions for each elementary forging operation were analysed according to the lubrication parameters, such as ageing of the soaping phosphate line, immersion time in the phosphating bath, and additional lubricants (drawing powder and cold heading oil). The results enabled: (i) better knowledge and control of the changing friction conditions as the forging procedures progress; (ii) predicting and remedying lubrication damage, and (iii) anticipating the geometric variations of the forged product according to the friction conditions. (C) 2001 Elsevier Science B.V. All rights reserved.

引用

页码：951 / 961

页数：11

共 17 条

[1]

ADJERID S, 1995, THESIS U VALENCIENNE

[2] The influence of hexametaphosphate on formation of zinc phosphate coatings for deep drawing of steel tubes [J].