Comparing Luminex NxTAG-Respiratory Pathogen Panel and RespiFinder-22 for Multiplex Detection of Respiratory Pathogens

Respiratory tract infection (RTI) involves a variety of viruses and bacteria, which can be conveniently detected by multiplex nucleic acid amplification testing (NAT). To compare the novel Luminex-based NxTAG-Respiratory Pathogen Panel (NxTAG-RPP) with the routine multiplex-ligation-NAT based RespiFinder-221 (RF-22), 282 respiratory specimens including nasopharyngeal swabs (71%), broncho-alveolar lavage (27%), throat swabs, tracheal secretions, and sputum (2%) from 116 children and 155 adults were extracted using a Corbett CAS1200 (Qiagen), and analyzed in parallel by the routine RF-22 and NxTAG-RPP. Concordant results were obtained in 263 (93.3%) cases consisting of concordant positives in 167 (59.2%) and concordant negatives in 96 (34%). Results were discordant in 19 (6.7%) consisting of 15 positive: negative, and 4 negative: positive results by NxTAG-RPP versus RF22, respectively. Co-infections were observed in 10.3% with NxTAG-RPP and in 5.9% with RF-22. Most additional viral pathogens identified by the NxTAG-RPP involved dual infections with rhinovirus and RSV. Discordant samples were mainly due to low genome signals of Ct less than 36, when retested by QNAT suggesting a higher sensitivity of the NxTAG-RPP, also when detecting multiple infections. Hands-on time after extraction for 24 and 96 samples was 0.25 and <0.5 hr for the NxTAG-RPP, and 2 and 4 hr for the RF-22, respectively. The median turn-around time was 6 hr (range 5-7 hr) for NxTAG-RPP and 12 hr (range 8-16 hr) for RF-22. The NxTAG-RPP showed comparable detection rates for most respiratory pathogens, while hands-on and turn-around time were considerably shorter. The clinical significance of detecting multiple viruses needs further clinical evaluation. (C) 2016 Wiley Periodicals, Inc.