Machining and fluidity of 356Al/SiC(p) composites

被引：33

作者：

Lin, CB ^{[1
]}

Hung, YW ^{[1
]}

Liu, WC ^{[1
]}

Kang, SW ^{[1
]}

机构：

[1] Tamkang Univ, Dept Engn Mech, Taipei 25137, Taiwan

来源：

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY | 2001年 / 110卷 / 02期

关键词：

aluminum particulate matrix composite; fluidity; machining; flank wear; roughness;

D O I：

10.1016/S0924-0136(00)00857-8

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The fluidity and machining of 365A1/0-20 wt.% SiC composites is discussed. Experimental result shows that non-uniformity arises when the content of the particulate reinforcement is increased. Using an are fluidity mold can prevent particulates from settling, and the fluidity length is shortened with an increase of SiC particulate content. When using a spiral mold. SiC particulates tend to settle in the gate and the runner. Therefore. the fluidity length does not change with a SiC particulate content, except for 20%. Increasing the SiC particulate content results in an increase of hardness. flank wear and roughness. When the SiC particulate content is the same, cutting at cryogenic temperature can reduce the chip length, flank wear and roughness. (C) 2001 Elsevier Science B.V. All rights reserved.

引用

页码：152 / 159

页数：8

共 19 条

[11] THE SOLIDIFICATION MICROSTRUCTURE OF PARTICULATE REINFORCED ALUMINIUM-SIC COMPOSITES [J].

LLOYD, DJ .

COMPOSITES SCIENCE AND TECHNOLOGY, 1989, 35 (02) :159-179

[12]

Lloyd DJ, 1988, P INT S ADV CAST REI, P263

[13]

LLOYD DJ, 1991, P 12 RIS INT S MAT S, P81

[14]

Richardson JF., 1954, Trans. Inst. Chem. Eng, V32, P35, DOI [DOI 10.1016/S0263-8762(97)80006-8, 10.11475/sabo1973.59.5_23, DOI 10.11475/SABO1973.59.5_23]

[15] SEGREGATION OF SILICON-CARBIDE BY SETTLING AND PARTICLE PUSHING IN CAST-ALUMINUM SILICON-CARBIDE PARTICLE COMPOSITES [J].