The structure and properties of copper oxide and copper aluminium oxide coatings prepared by pulsed magnetron sputtering of powder targets

被引:102
作者
Alkoy, EM
Kelly, PJ
机构
[1] Univ Salford, Surface Engn Grp, Salford M5 4WT, Lancs, England
[2] Kocaeli Univ, Dept Phys, TR-41300 Kocaeli, Turkey
关键词
pulsed magnetron sputtering; powder targets; p-type semiconductors; copper oxide coatings; copper aluminium oxide coatings;
D O I
10.1016/j.vacuum.2005.03.011
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The development of p-type semiconductor, is one of the key technologies for p-n junction-based devices, such as diodes, transistors and li.-ht-emitting diodes. Copper oxide and copper aluminium oxide (CuAlO2) coatings are known to show p-type conductivity and, as a consequence, these materials are attracting increasing attention. In this study, therefore, various copper oxide and CuAlO2 films were deposited by pulsed magnetron sputtering from loosely packed powder targets, formed from either Cu2O powder alone, or blends of Cu2O and Al2O3 powders, in a rig specifically designed for the purpose. The coatings were deposited at varying partial pressures of oxygen and then annealed at atmospheric pressure. The optical, electrical and structural properties were determined using a range of techniques including spectrophotometry, four-point probe, scanning electron microscopy and X-ray diffraction. Analysis of the films showed that, in the former case, crystalline Cu2O and CuO structures could be produced, depending on the oxygen partial pressure during deposition and the post-deposition annealing conditions. The as-deposited Cu2O films were found to have a very high optical transmittance in the visible range with up to 95 % transmission. In comparison, the CuO films showed lower transmittance in the visible range, but greater transmittance in the IR range. The optical band gaps obtained from the transmittance and reflectance measurements were 2.44 and 1.78 eV for Cu2O and CuO, respectively. The CuAlO2 coatings were also found to be crystalline, with optical and electrical properties again dependant on the deposition and annealing conditions. The direct deposition of transparent conductive oxide films front loosely packed powder targets by pulsed magnetron sputtering is a novel. highly versatile technique for the deposition of this type of material. (c) 2005 Elsevier Ltd. All rights reserved.
引用
收藏
页码:221 / 230
页数:10
相关论文
共 25 条
[1]  
AUDRONIS M, IN PRESS SURF COAT T
[2]   Optical and structural properties of nanocrystalline copper oxide thin films prepared by activated reactive evaporation [J].
Balamurugan, B ;
Mehta, BR .
THIN SOLID FILMS, 2001, 396 (1-2) :90-96
[3]   Low-threshold field emission from transparent p-type conducting CuAlO2 thin film prepared by dc sputtering [J].
Banerjee, AN ;
Chattopadhyay, KK .
APPLIED SURFACE SCIENCE, 2004, 225 (1-4) :243-249
[4]   Synthesis and characterization of p-type transparent conducting CuAlO2 thin film by DC sputtering [J].
Banerjee, AN ;
Kundoo, S ;
Chattopadhyay, KK .
THIN SOLID FILMS, 2003, 440 (1-2) :5-10
[5]   Preparation of p-type transparent conducting CuAlO2 thin films by reactive DC sputtering [J].
Banerjee, AN ;
Maity, R ;
Chattopadhyay, KK .
MATERIALS LETTERS, 2004, 58 (1-2) :10-13
[6]   Deposition of thin films of different oxides of copper by RF reactive sputtering and their characterization [J].
Ghosh, S ;
Avasthi, DK ;
Shah, P ;
Ganesan, V ;
Gupta, A ;
Sarangi, D ;
Bhattacharya, R ;
Assmann, W .
VACUUM, 2000, 57 (04) :377-385
[7]   P-type electrical conduction in transparent thin films of CuAlO2 [J].
Kawazoe, H ;
Yasukawa, M ;
Hyodo, H ;
Kurita, M ;
Yanagi, H ;
Hosono, H .
NATURE, 1997, 389 (6654) :939-942
[8]  
KAWAZOE H, 2000, B MRS, P28
[9]   Advanced coatings through pulsed magnetron sputtering [J].
Kelly, PJ ;
Hisek, J ;
Zhou, Y ;
Pilkington, RD ;
Arnell, RD .
SURFACE ENGINEERING, 2004, 20 (03) :157-162
[10]   A novel technique for the deposition of aluminium-doped zinc oxide films [J].
Kelly, PJ ;
Zhou, Y ;
Postill, A .
THIN SOLID FILMS, 2003, 426 (1-2) :111-116