A numerical evaluation of SAR distribution and temperature changes around a metallic plate in the head of a RF exposed worker

被引:61
作者
McIntosh, RL
Anderson, V
McKenzie, RJ
机构
[1] Telstra Res Labs, Clayton, Vic 3168, Australia
[2] EME Australia, Frankston, Australia
关键词
occupational radiofrequency exposure; safety standards; cranioplasty; metallic implants; Pennes bioheat equation; finite difference;
D O I
10.1002/bem.20112
中图分类号
Q [生物科学];
学科分类号
07 ; 0710 ; 09 ;
摘要
The 1998 International Commission for Non-Ionising Radiation (ICNIRP) Guidelines for human exposure to radiofrequency (RF) fields contain a recommendation to assess the potential impact of metallic implants in workers exposed up to the allowable occupational field limits. This study provides an example of how numerical electromagnetic (EM) and thermal modelling can be used to determine whether scattered RF fields around metallic implants in workers exposed to allowable occupational ambient field limits will comply with the recommendations of relevant standards and guidelines. A case study is performed for plane wave exposures of a 50 mm diameter titanium cranioplasty plate, implanted around 5-6 mm under the surface of the forehead. The level of exposures was set to the ambient power flux density limits for occupational exposures specified in the 1998 ICNIRP guidelines and the cur-rent 1999 IEEE C95.1 standard over the frequency range 100-3000 MHz. Two distinct peak responses were observed. There was a resonant response for the whole implant at 200-300 MHz where the maximum dimension of the implant is around a third of the wavelength of the RF exposure. This, however, resulted in relatively low peak specific energy absorption rate (SAR) levels around the implant at the exposure limits. Between 2100-2800 MHz, a second SAR concentrating mechanism of constructive interference of the wave reflected back and forth between the air-scalp interface and the scalp-plate interface resulted in higher peak SARs that were within the allowable limits for the ICNIRP exposures, but not for the IEEE C95.1 exposures. Moreover, the IEEE peak SAR limits were also exceeded, to a lesser degree, even when the implant was not present. However, thermal modelling indicated that the peak SAR concentrations around the implant did not result in any peak temperature rise above 1 degrees C for occupational exposures recommended in the ICNIRP guidelines, and hence would not pose any significant health risk. (c) 2005 Wiley-Liss, Inc.
引用
收藏
页码:377 / 388
页数:12
相关论文
共 53 条
[31]   TEMPERATURE DISTRIBUTIONS IN THE HUMAN LEG FOR VLF-VHF EXPOSURES AT THE ANSI-RECOMMENDED SAFETY LEVELS [J].
HOQUE, M ;
GANDHI, OP .
IEEE TRANSACTIONS ON BIOMEDICAL ENGINEERING, 1988, 35 (06) :442-449
[32]  
*IEEE INC, 1999, C951 IEEE INC
[33]  
*IEEE INC, 2004, IEEE STAND SAF LEV R
[34]   TEMPERATURE PROFILES IN SPHERES DUE TO ELECTROMAGNETIC HEATING [J].
KRITIKOS, HN ;
FOSTER, KR ;
SCHWAN, HP .
JOURNAL OF MICROWAVE POWER AND ELECTROMAGNETIC ENERGY, 1981, 16 (3-4) :327-344
[35]  
Kunz K. S., 1993, FINITE DIFFERENCE TI
[37]   Computed SAR and thermal elevation in a 0.25-mm 2-D model of the human eye and head in response to an implanted retinal stimulator - Part II: Results [J].
Lazzi, G ;
DeMarco, SC ;
Liu, WT ;
Weiland, JD ;
Humayun, MS .
IEEE TRANSACTIONS ON ANTENNAS AND PROPAGATION, 2003, 51 (09) :2286-2295
[38]  
McIntosh RL, 2003, APPL COMPUT ELECTROM, P107
[39]  
MCKINLAY AF, 1993, 4 NRPB
[40]  
*NAT LIB MED, 2004, VIS HUM PROJ