The signal-to-noise ratio as the measure for the quantification of lysophospholipids by matrix-assisted laser desorption/ionisation time-of-flight mass spectrometry

The subject of this report is the determination of lysophospholipids; lysophosphatidylcholine, lysophosphatidylethanolamine, lysophosphatidylserine and lysophosphatidic acid, by matrix-assisted laser desorption/ionisation time-of-flight mass spectrometry (MALDI-TOF MS). The mean signal-to-noise ratio (S/N) was used for the first time as a measure of lysophospholipid concentration. Two different sample preparation procedures were applied, the 'standard' procedure and the 'premix' in order to check to what extent these methods influence the results of the lysophospholipid quantification. Results can be summarised as follows: (a) All classes of lysophospholipids can be easily and sensitively analysed by MALDI-TOF MS. The smallest detectable amount of lysophospholipids was 0.09 pmol on the sample plate. That is about two orders of magnitude lower than the amount detectable by standard chromatographic methods. (b) The mean S/N of all peaks detected in the positive ion mass spectra can be used as a measure of the lysophospholipid concentration. Whereas the S/N for neutral lysophospholipids correlated with the applied concentrations only when the samples were analysed as 'premix', the sample preparation and application procedure did not influence the quantification of acidic lysophospholipids. The standard deviations were not higher than 10% of the mean value. (c) All spectra were additionally analysed in the presence of CsCl. The addition of caesium ions makes the peak identification unambiguous in phospholipid mixtures, but the Cs adducts of lysophospholipids do not properly reflect their concentration and, therefore, they were not useful for quantification. (d) The applicability of the method was demonstrated on the organic extract of human neutrophils.