Adjacent-level biomechanics after single versus multilevel cervical spine fusion Laboratory investigation

Object. Previous studies have demonstrated that patients with spinal fusion are at greater risk for adjacent-segment disease and require additional surgery. It has been postulated that excessive motion of a given motion segment unit (MSU) leads to an increased risk of disc degeneration. It is the authors' hypothesis that a greater increase in adjacent-segment motion will be observed following a 2-level versus a single-level anterior cervical discectomy and instrumented fusion (ACDF). Therefore, they undertook this study to determine the effect of single-level versus 2-level ACDF on the biomechanics of adjacent MSUs. Methods. Ten fresh-frozen human cervical spines were used in this study. The specimens were potted at C-4 and T-1 and tested in flexion and extension. Range of motion (ROM) was 30 degrees of flexion and 15 degrees of extension at a maximum load of 50 N. The specimens were tested intact and then were randomized into 2 groups of 5 specimens each. Group I underwent a single-level ACDF at the C5-6 level first, and Group 2 underwent the procedure at the C6-7 level. After testing, both groups had the fusion extended to include the C5-7 levels, and the testing was repeated. Changes in overall ROM, stiffness, and segmental motion were calculated and statistically analyzed using a paired Student t-test. Results. An increase in sagittal ROM of 31.30% above (p = 0.012) and 33.88% below (p = 0.066) the fused MSU was found comparing a 2-level with a 1-level ACDF. The overall stiffness of the entire spinal construct increased 37.34% (p = 0.051) in extension and 30.59% (p = 0.013) in flexion as the second fusion level was added. As expected, the overall sagittal ROM of the entire spinal construct decreased by 13.68% (p = 0.0014) with a 2-level compared with a 1-level fusion. Conclusions. This study has shown that the biomechanics at adjacent levels to a cervical spine fusion are altered and that there is increased adjacent-segment motion at the levels above and below, after a 2-level compared with a 1-level ACDF. (DOI: 10.3171/2011.10.SPINE11116)