Computing offsets of trimmed NURBS surfaces

Offsetting of trimmed NURBS surfaces is one of the widely used functionalities in the design and manufacture simulations of composite laminates. This paper presents an approach for the offsetting of a trimmed NURBS surface. The approach has been developed mainly to meet the stringent accuracy requirements in the simulation of composite laminate design and manufacturing processes. However, the approach is applicable for the offset of a general trimmed NURBS surface. Though the method is based on known techniques in literature, the practical approach and the treatment of the subject presented is unique and has not been reported earlier. The basic approach consists of offsetting the underlying surface, offsetting of all the trimming loops and the creation of offset trimmed surface using the offset surface and the offset trimming loops. This is a unified offset approach for trimmed surfaces where in the offset of underlying surface and the offset of trimming loops are obtained using the same approach. The approach has better error control and results in less number of control points. Further the approach can be extended to obtain offsets of a general B-Rep. The approach has been used in the creation of offset surfaces of various aircraft components. (C) 2002 Elsevier Science Ltd. All rights reserved.