Ti-Si alloys with the nominal composition of Ti14S86, Ti16Si84, Ti21Si79 were rapidly solidified using a single roller melt spinning technique. The melt-spun Ti-Si ribbon powders were mechanically milled with graphite powders, followed by the carbon coating through pyrolysis of coal tar pitch at 900 degrees C under argon flow. These composite electrodes exhibit good cycle performance, especially when the Si content in the Ti-Si alloy is below the composition of the Si+TiSi2 eutectic. (c) 2006 Elsevier Ltd. All rights reserved.
机构:Seoul Natl Univ, Sch Mat Sci & Engn, Res Ctr Energy Convers & Storage, Seoul 151742, South Korea
Kim, JH
;
论文数: 引用数:
h-index:
机构:
Kim, H
;
Sohn, HJ
论文数: 0引用数: 0
h-index: 0
机构:
Seoul Natl Univ, Sch Mat Sci & Engn, Res Ctr Energy Convers & Storage, Seoul 151742, South KoreaSeoul Natl Univ, Sch Mat Sci & Engn, Res Ctr Energy Convers & Storage, Seoul 151742, South Korea
机构:Seoul Natl Univ, Sch Mat Sci & Engn, Res Ctr Energy Convers & Storage, Seoul 151742, South Korea
Kim, JH
;
论文数: 引用数:
h-index:
机构:
Kim, H
;
Sohn, HJ
论文数: 0引用数: 0
h-index: 0
机构:
Seoul Natl Univ, Sch Mat Sci & Engn, Res Ctr Energy Convers & Storage, Seoul 151742, South KoreaSeoul Natl Univ, Sch Mat Sci & Engn, Res Ctr Energy Convers & Storage, Seoul 151742, South Korea