Manufacturing of solid oxide fuel cells -: A challenge for DC and RF plasma deposition processes

被引：4

作者：

Henne, RH ^{[1
]}

Lang, M ^{[1
]}

Müller, M ^{[1
]}

Ruckdäschel, R ^{[1
]}

Schiller, G ^{[1
]}

机构：

[1] Deutsch Zentrum Luft & Raumfahrt eV, Inst Tech Thermodynam, D-70569 Stuttgart, Germany

来源：

HEAT AND MASS TRANSFER UNDER PLASMA CONDITIONS | 1999年 / 891卷

关键词：

D O I：

10.1111/j.1749-6632.1999.tb08759.x

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

It is expected that fuel cells and particularly solid oxide fuel cells (SOFC) as direct converters of chemical energy into electrical energy will gain an important position in future stationary electric power generation. SOFCs of present development state operate in a temperature range of around 900 degrees C. Their efficiency is considerably higher and their operation less burdened by wastes and environmental problems compared to presently applied systems. Therefore, there exists great interest to make such SOFC units available in a technical scale. A main precondition for a wide spread application of SOFCs is particularly a considerable reduction of the production costs, Besides the improvement of presently used methods mainly basing on sintering techniques, also new technologies have been under consideration and development. In this connection DC and RF plasma deposition processes became attractive for producing components or even entire cells, But further process improvements are needed to meet the special quality and economic demands of the SOFCs.

引用

页码：124 / 136

页数：13

共 22 条

[1]

Beie HJ, 1997, ELEC SOC S, V97, P51

[2]

Boulos M.I., 1992, J THERM SPRAY TECHN, V1, P33

[3]

Diethelm R, 1997, ELEC SOC S, V97, P79

[4]

Fendler E., 1996, Second European Solid Oxide Fuel Cell Forum. Proceedings, P269

[5]

Gruner H., 1996, Second European Solid Oxide Fuel Cell Forum. Proceedings, P261

[6]

HAERING C, IN PRESS DEGRADATION

[7] Near-net-shape forming of metallic bipolar plates for planar solid oxide fuel cells by induction plasma spraying [J].

Henne, R ;

Müller, M ;

Pross, E ;

Schiller, G ;

Gitzhofer, F ;

Boulos, M .

JOURNAL OF THERMAL SPRAY TECHNOLOGY, 1999, 8 (01) :110-116

[8]

HENNE R, 1997, P 14 INT PLANS SEM R, V1, P231

[9]

HENNE R, 1993, DVS BERICHTE, V152, P7

[10]

HENNE R, 1998, P 15 ITSC NIC FRANC

← 1 2 3 →