Triode plasma nitriding and PVD coating: A successful pre-treatment combination to improve the wear resistance of DLC coatings on Ti6Al4V alloy

Diamond-like carbon (DLC) coatings have found great applicability in the automotive industry because of their low friction coefficient and high wear resistance. Nevertheless, their tribological performance can be greatly reduced on soft substrates such as titanium alloys. The hard DLC coating cannot usually follow elastic and plastic deformation of the substrate without failing. In order to overcome this property mismatch between hard coating and soft substrate, triode plasma nitriding was applied as a pre-treatment to improve the mechanical properties of the Ti6Al4V alloy and further enhance the load support for the DLC coating. DLC and multilayered TiN/DLC, CrN/DLC CrAIN/DLC coatings were deposited onto "standard" and plasma nitrided Ti6A14V substrates. Triode plasma nitriding increased the load-bearing capacity of the coating/substrate system, as higher critical adhesion loads were recorded for DLC coatings on plasma nitrided Ti6Al4V substrates. This treatment also reduced the wear rate of the DLC coating/substrate. Further load support and lower wear rates were achieved by using TiN, CrN and CrAIN as intermediate layers on plasma nitrided Ti6Al4V substrates. (c) 2006 Elsevier B.V. All rights reserved.