Comparison of different methods for determination of drip loss and their relationships to meat quality and carcass characteristics in pigs

Samples of the M. longissimus dorsi of 776 pigs from three commercial lines were used to compare two methods for measuring drip loss, referred to as the EZ-DripLoss and bag methods. Furthermore, relationships between drip loss and other meat quality and carcass traits were analysed. The bag method used a slice of M. longissimus dorsi of approximately 120 g hung in an airtight container whereas the EZ-DripLoss method used two samples of approximately 10 g placed in drip loss containers. In the bag method, samples taken at 24 h post-mortem were measured 24 and 48 h after sampling and average drip loss was 1.94% and 3.33% at 24 and 48 h, respectively. Correlation between these consecutive measurements was high (r = 0.98). Using the EZ-DripLoss method, drip loss of samples taken at 24 h post-mortem was measured 48 h after sampling and showed an average value of 4.97%. Correlation between the drip loss obtained using EZ-DripLoss and bag methods was high (r = 0.86). Relationships between drip loss and other meat quality traits were similar for both methods. Highest correlations were observed between drip loss and pH(45) (r = -0.52 and -0.48 using EZ-DripLoss method(48) and bag method(48), respectively) and the lowest to Minolta a* value (r = 0.11 and 0.09, respectively). Correlations among several carcass traits, such as lean content, and drip loss were low or not significant. Low associations between loin eye area (cm(2)) and drip loss were obtained regardless of the method used to determine drip loss (r = 0.21 and 0.18 using EZ-DripLoss method(48) and bag method(48), respectively). For routine measurements, the EZ-DripLoss method is recommended because it showed a high correlation with the bag method but is easier to perform and is more standardised. (C) 2004 Elsevier Ltd. All rights reserved.