Electrodeposition of amorphous/nanocrystalline and polycrystalline Ni-Mo alloys from pyrophosphate baths

Pyrophosphate plating bath was found to be a good alternative to citrate bath for deposition of Ni-Mo amorphous alloys. The addition of wetting agents such as 2-butyne-1,4-diol and rokafenol N-10 to the pyrophosphate bath resulted in the removal of bumps, spheres and cracks from the Ni-Mo alloy surface. The plated alloy layers adhered well to Cu-Zn brass and steel, were of thickness from a fraction to tens of micrometers and the molybdenum content was independent of the distance from the support. An increase in the concentration of the molybdate ion in the bath leads to an increase in the amount of Mo in the alloys up to 33-35 at.% and to a decrease in the deposition rate. These changes and the influence of pH are discussed in the paper. The atom arrangement in the alloys changes from (220) preferred for pure-nickel deposition to (1 1 1) for content of Mo higher than 15 at.%. For 20 and more at.% of Mo the structure of the alloy is amorphous like. An analysis of SEM and STM micrographs obtained indicates that contrary to the Ni-W alloy the "amorphous" phase is made of circa 10-50nm in diameter objects and not by long needles perpendicular to the substrate. (C) 2004 Elsevier Ltd. All rights reserved.