Polymer-ceramic nanocomposite capacitors for system-on-package (SOP) applications

This work focuses on optimizing the dispersion of nanosized ceramic particles for achieving higher dielectric constant, thereby higher capacitance density in polymer/ceramic nanocomposites. It has been observed that high solids loading leads to entrapment of porosity in the microstructure which lowers the effective dielectric constant of the films. The amount of solvent in the suspension and the speed at which spin coating was performed were found to impact the dielectric constant of high filler content nanocomposites. The interplay between the rheological properties of the suspension and processing parameters such as solvent content. and coating speeds and its impact on the dielectric properties of the film are discussed. Porosity of thin film composites was measured for the first time to study the impact of these processing parameters. Powders of different particle sizes were mixed to obtain bimodal particle size distribution in order to increase the. packing density of the composite. Packing density was improved by modifying the dispersion methodology. A nanocomposite with dielectric constant as high as 135 was obtained for the first time in the low-cost printed wiring board compatible epoxy system. A capacitance densities of similar to35 nF/cm(2) on a nominal 3.5 micrometer films was achieved on PWB substrates with high yield. The manufacturability of these formulated nanocomposites and their applications as decoupling capacitors have been tested using a large Area (300 mm x 300 mm) system-on-package (SOP) chip-to-chip communication test vehicle.