DUCTILE-REGIME MACHINING OF GERMANIUM AND SILICON

被引：346

作者：

BLAKE, PN ^{[1
]}

SCATTERGOOD, RO ^{[1
]}

机构：

[1] N CAROLINA STATE UNIV,CTR PRECIS ENGN,RALEIGH,NC 27695

来源：

JOURNAL OF THE AMERICAN CERAMIC SOCIETY | 1990年 / 73卷 / 04期

关键词：

germanium; machining; mechanical properties; plasticity; silicion;

D O I：

10.1111/j.1151-2916.1990.tb05142.x

中图分类号：

TQ174 [陶瓷工业]; TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

Precision machining of germanium and silicon was studied using single‐point diamond turning. Special attention was directed to the so‐called ductile regime wherein optical quality surface finishes can be machined directly on brittle materials. A novel interrupted‐cutting test and a new model of the machining process were used to measure a critical‐depth parameter experimentally. This parameter governs the transition from plastic flow to fracture along the tool nose. The critical‐depth parameter can be used to provide physical insight into the effect of various machining parameters such as tool rake angle or tool clearnace angle. Because of a complex interplay between tool geometry, machining parameters, and material response, a large fraction of material removal occurs by fracture even when ductile‐regime conditions are achieved. Copyright © 1990, Wiley Blackwell. All rights reserved

引用

页码：949 / 957

页数：9