EFFECTS OF CONCENTRATED MATRICES ON THE DETERMINATION OF TRACE LEVELS OF PLATINUM AND GOLD IN AQUEOUS SAMPLES USING SOLVENT EXTRACTION-ZEEMAN EFFECT GRAPHITE-FURNACE ATOMIC-ABSORPTION SPECTROMETRY AND INDUCTIVELY COUPLED PLASMA-MASS SPECTROMETRY

Two methods of determining trace levels of platinum and gold in aqueous solutions with high concents of total dissolved solids were investigated. The first involves preconcentration and separation of the precious metals from the interfering matrix by solvent extraction, followed by graphite furnace atomic absorption spectrometry (GFAAS) with Zeeman effect background correction. The direct determination of Pt and Au in solutions of high ionic strength by GFAAS is not desirable because of interference between elements in the matrix and the analyte, increased imprecision of analysis, greatly increased background absorbance leading to increased detection limits and rapid deterioration of the graphite tube. All the extraction methods for gold examined in this study resulted in decreased imprecision, increased sensitivity and lower background absorbance compared with direct measurements on the aqueous solution. All techniques also exhibited good recoveries (> 8%) and reproducibilities (relative standard deviation < 10%). The highest sensitivities for gold extraction from distilled water were obtained for dibutyl sulfide (DBS)-toluene and the lowest for cyanide-dibutyl ketone. The degree of extraction of Au was, however, dependent on the composition of the solution, indicating that standard and sample matrices should be closely matched even when employing solvent extraction. Solvent extraction was generally less successful for Pt. In order to obtain an acceptable imprecision in the Pt extractions, it was found that the use of SnCl2 as a labilizing agent is essential for most of the techniques investigated. The second method was direct measurement by inductively coupled plasma mass spectrometry (ICP-MS). ICP-MS offers the advantages of a very low detection limit (100 ng l-1 or better) without preconcentration and a large dynamic range. However, severe matrix effects can occur in concentrated solutions. Whereas high concentrations in solution of both sodium perchlorate and sodium chloride decrease the sensitivity, the presence of sulfide and natural organic (fulvic) acid increase the sensitivity for Pt and Au by a factor of up to 4. Sulfate, on the other hand, decreases the sensitivity of ICP-MS for Pt. The method of standard additions or isotope dilution is recommended for routine use to circumvent this problem, especially when the nature of the matrix is unknown or cannot be easily matched in the standards. © 1990.