PRIMARY MAGMAS OF MIDOCEAN RIDGE BASALTS .1. EXPERIMENTS AND METHODS

This paper reports experiments carried out between 9 and 16 kbar (0.9-1.6 GPa) using natural, primitive mid-ocean ridge basalt compositions and synthetic analogs of mid-ocean ridge basalts to investigate the effects of pressure, temperature, and variable bulk composition on the composition of melts multiply saturated with the minerals present in the upper oceanic mantle: olivine, orthopyroxene, augite, and plagioclase or spinel. For this low-variance, five-phase assemblage, equations involving pressure, melt NaK # ([Na2O + K2O]/[Na2O + K2O + CaO]; weight ratio), melt Mg # (Mg/[Mg + Fe2+]; total iron as Fe2+), and weight percent TiO2 in the melt predict temperature and major element compositions of magmas produced by melting spinel and plagioclase lherzolites at upper mantle pressures. The equations are estimated using a selected set of data from this experimental study and published experimental studies that report compositions of glasses coexisting with olivine, low-Ca pyroxene, augite, and plagioclase and/or spinel. An experimental test of a liquid compositionally similar to melts produced in a subset of peridotite-basalt sandwich experiments is presented. The composition tested was reported as multiply saturated (with orthopyroxene + augite + spinel + olivine) in the sandwich experiment, but it does not crystallize these phases at the conditions of the experiment. We exclude this liquid and the subset it represents (data from Fujii and Scarfe [1985] and Falloon and Green [1987]) from the data set used to constrain the melting equilibria. With estimates of the mell NaK #, melt Mg #, and weight percent TiO2 of the melt the quantitative descriptions of the melting equilibria can be used to predict the temperatures and major element compositions of melts from lherzolite. Methods are described for estimating these compositional parameters with the nonmodal batch melting equation (for Na2O, CaO, K2O, and TiO2) and a mass balance calculation (for MgO and FeO) from the initial composition and phase proportions of the mantle source, the amount of melt produced and the nature of the melting process, and the stoichiometric coefficients of the mantle melting reaction.