Inexpensive, quickly producable X-ray mask for LIGA

The capability to produce X-ray masks inexpensively and rapidly is expected to greatly enhance the commercial appeal of the LIGA process. This paper presents a process to fabricate X-ray masks both inexpensively (under $1000) and rapidly (within a few days). The process involves one UV lithography step and eliminates the need for an intermediate X-ray mask. The X-ray mask produced by this process consists of a 125 mu m thick graphite membrane that supports a gold-on-nickel absorber pattern. The thickness of the absorber structures is great enough to supply sufficient contrast even when radiation sources with high characteristic photon energies up to 40 keV are utilized and/or when deep exposures are desired. The mask fabrication process is initiated by spin coating 30-50 mu m of SU-8 directly on a graphite membrane. The SU-8 is then patterned using a UV mask. Gold-on-nickel absorber structures are electroplated directly onto the SU-8 covered graphite. Once the remaining SU-8 is removed, attaching the graphite membrane to a frame completes the mask. To test the performance of the mask, a nickel mold insert was fabricated. A sheet of PMMA 500 mu m in thickness was bonded to a nickel substrate, then exposed to X-rays through the mask, and developed. Electroplating nickel into the patterned PMMA sheet produced a mold insert. SEM pictures taken of the SU-8, the X-ray mask, and the mold insert are shown. This method of rapidly producing an inexpensive X-ray mask for LIGA resulted in a mold insert with smooth, vertical sidewalls whose dimensions were within two micrometers of the UV mask dimensions.